On Mon, Jun 17, 2019 at 06:14:32PM +0200, Marco Felsch wrote: > From: Michael Grzeschik <m.grzeschik@xxxxxxxxxxxxxx> > > The patch adds the following interfaces according the SMARC Spec 1.1 > [1] and provided schematics: > - SMARC SPI0/1 > Note: Since Kontron still uses silicon revisions below 1.3 they have > add a spi-nor to implement Workaround #1 of erratum ERR006282. > - SMARC SDIO > - SMARC LCD > - SMARC HDMI > - SMARC Management pins > Note: Kontron don't route all of these pins to the i.MX6, some are > routed to the SoM CPLD. > - SMARC GPIO > - SMARC CSI Camera > Note: As specified in [1] the data lanes are shared to cover the > csi and the parallel case. The case depends on the baseboard so > muxing the data lanes is not part of this patch. > - SMARC I2S > - SMARC Watchdog > Note: The watchdog output pin is routed to the CPLD and the SMARC > header. The CPLD performs a reset after a 30s timeout so we > need to enable the watchdog per default. > - SMARC module eeprom > > Due to the lack of hardware not all of these interfaces are tesetd. > > [1] https://sget.org/standards/smarc > > Signed-off-by: Marco Felsch <m.felsch@xxxxxxxxxxxxxx> Applied, thanks.
