From: Doug Anderson <dianders@xxxxxxxxxxxx>
This enables wake up on Bluetooth activity when the device is
suspended. The BT_HOST_WAKE signal is only connected on devices
with BT module that are connected through UART.
Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
Signed-off-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
---
Changes in v2:
- attributed authorship to Doug
- use constant instead of literal for pin number
---
arch/arm/boot/dts/rk3288-veyron.dtsi | 29 ++++++++++++++++++++++++++++
1 file changed, 29 insertions(+)
diff --git a/arch/arm/boot/dts/rk3288-veyron.dtsi b/arch/arm/boot/dts/rk3288-veyron.dtsi
index 3257ca90f0e8..e2635ad574e7 100644
--- a/arch/arm/boot/dts/rk3288-veyron.dtsi
+++ b/arch/arm/boot/dts/rk3288-veyron.dtsi
@@ -23,6 +23,31 @@
reg = <0x0 0x0 0x0 0x80000000>;
};
+ bt_activity: bt-activity {
+ compatible = "gpio-keys";
+ pinctrl-names = "default";
+ pinctrl-0 = <&bt_host_wake>;
+
+ /*
+ * HACK: until we have an LPM driver, we'll use an
+ * ugly GPIO key to allow Bluetooth to wake from S3.
+ * This is expected to only be used by BT modules that
+ * use UART for comms. For BT modules that talk over
+ * SDIO we should use a wakeup mechanism related to SDIO.
+ *
+ * Use KEY_RESERVED here since that will work as a wakeup but
+ * doesn't get reported to higher levels (so doesn't confuse
+ * Chrome).
+ */
+ bt-wake {
+ label = "BT Wakeup";
+ gpios = <&gpio4 RK_PD7 GPIO_ACTIVE_HIGH>;
+ linux,code = <KEY_RESERVED>;
+ wakeup-source;
+ };
+
+ };
+
power_button: power-button {
compatible = "gpio-keys";
pinctrl-names = "default";
@@ -549,6 +574,10 @@
rockchip,pins = <4 RK_PD5 RK_FUNC_GPIO &pcfg_pull_none>;
};
+ bt_host_wake: bt-host-wake {
+ rockchip,pins = <4 RK_PD7 RK_FUNC_GPIO &pcfg_pull_down>;
+ };
+
/*
* We run sdio0 at max speed; bump up drive strength.
* We also have external pulls, so disable the internal ones.
--
2.22.0.rc2.383.gf4fbbf30c2-goog
