Hi Miquel,
> From: Konstantin Porotchkin <kostap@xxxxxxxxxxx>
>
> While AP I2C bus was available to users in early revisions of the SoC,
> this is not the case anymore since eMMC was connected to the AP. Most
> users do not have access to this I2C bus so do not enable it in the
> board device tree.
>
> As there are three I2C buses enabled on this board, add an alias to be
> sure the two other buses keep their initial numbering.
>
> Signed-off-by: Konstantin Porotchkin <kostap@xxxxxxxxxxx>
> [<miquel.raynal@xxxxxxxxxxx>: Reword commit message, add alias]
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Applied on mvebu/dt64
Thanks,
Gregory
> ---
> arch/arm64/boot/dts/marvell/armada-8040-db.dts | 7 ++-----
> 1 file changed, 2 insertions(+), 5 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
> index 9f4f939ab65f..d6e9c014c2f9 100644
> --- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts
> +++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
> @@ -27,6 +27,8 @@
> ethernet1 = &cp0_eth2;
> ethernet2 = &cp1_eth0;
> ethernet3 = &cp1_eth1;
> + i2c1 = &cp0_i2c0;
> + i2c2 = &cp1_i2c0;
> };
>
> cp0_reg_usb3_0_vbus: cp0-usb3-0-vbus {
> @@ -72,11 +74,6 @@
> };
> };
>
> -&i2c0 {
> - status = "okay";
> - clock-frequency = <100000>;
> -};
> -
> &spi0 {
> status = "okay";
>
> --
> 2.19.1
>
--
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com
