add support for the pinconf DT property output-enable, output-disable, output-low and output-high in the meson pinctrl driver. Signed-off-by: Jerome Brunet <jbrunet@xxxxxxxxxxxx> --- .../devicetree/bindings/pinctrl/meson,pinctrl.txt | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-) diff --git a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt index a7618605bf1e..10dc4f7176ca 100644 --- a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt @@ -47,9 +47,15 @@ Required properties for pinmux nodes are: Required properties for configuration nodes: - pins: a list of pin names -Configuration nodes support the generic properties "bias-disable", -"bias-pull-up" and "bias-pull-down", described in file -pinctrl-bindings.txt +Configuration nodes support the following generic properties, as +described in file pinctrl-bindings.txt: + - "bias-disable" + - "bias-pull-up" + - "bias-pull-down" + - "output-enable" + - "output-disable" + - "output-low" + - "output-high" Optional properties : - drive-strength-microamp: Drive strength for the specified pins in uA. -- 2.20.1
