NOTE:
This series requires the follow patch from Shimoda-san.
[PATCH v2] usb: renesas_usbhs: Use specific struct instead of USBHS_TYPE_* enums
For the most part, the RZ/A2 has the same USB 2.0 host and device
HW as the R-Car Gen3, so we can reuse a lot of the code.
However, there are a couple extra register bits, and the CFIFO
register 8-bit access works a little different.
There is a dedicated DMAC for the RZ/A2 USB Device HW, but we
have not been able to reliably get that working yet, so device
operation is pio only at the moment.
On the RZ/A2M eval board, both USB channels can be used as either
host or device. But, it's not set up for otg (ie, there are jumpers
and separate connectors). Therefore, below is an example of what it
would look like to enable USB channel 0 as a device instead of a host.
&usb2_phy0 {
pinctrl-names = "default";
pinctrl-0 = <&usb0_pins>;
dr_mode = "peripheral";
status = "okay";
};
&usbhs0 {
status = "okay";
};
Chris Brandt (15):
ARM: dts: r7s9210: Add USB clock
ARM: dts: rza2mevb: Add 48MHz USB clock
phy: renesas: rcar-gen3-usb2: detect usb_x1 clock
dt-bindings: rcar-gen3-phy-usb2: Document use of usb_x1
phy: renesas: rcar-gen3-usb2: Check dr_mode when not using OTG
dt-bindings: rcar-gen3-phy-usb2: Document dr_mode
dt-bindings: rcar-gen3-phy-usb2: Add r7s9210 support
usb: renesas_usbhs: move flags to param
usb: renesas_usbhs: add support for CNEN bit
usb: renesas_usbhs: support byte addressable CFIFO
usb: renesas_usbhs: Add support for RZ/A2
dt-bindings: usb: renesas_usbhs: Add support for r7s9210
ARM: dts: r7s9210: Add USB Host support
ARM: dts: r7s9210: Add USB Device support
ARM: dts: rza2mevb: Add USB host support
.../devicetree/bindings/phy/rcar-gen3-phy-usb2.txt | 19 +++--
.../devicetree/bindings/usb/renesas_usbhs.txt | 2 +
arch/arm/boot/dts/r7s9210-rza2mevb.dts | 42 ++++++++++
arch/arm/boot/dts/r7s9210.dtsi | 97 ++++++++++++++++++++++
drivers/phy/renesas/phy-rcar-gen3-usb2.c | 26 ++++++
drivers/usb/renesas_usbhs/Makefile | 2 +-
drivers/usb/renesas_usbhs/common.c | 44 ++++++----
drivers/usb/renesas_usbhs/common.h | 3 +-
drivers/usb/renesas_usbhs/fifo.c | 9 +-
drivers/usb/renesas_usbhs/rza.h | 1 +
drivers/usb/renesas_usbhs/rza2.c | 75 +++++++++++++++++
include/linux/usb/renesas_usbhs.h | 4 +
12 files changed, 298 insertions(+), 26 deletions(-)
create mode 100644 drivers/usb/renesas_usbhs/rza2.c
--
2.16.1
