Hi, On Mon, Apr 8, 2019 at 3:21 PM Doug Anderson <dianders@xxxxxxxxxxxx> wrote: > > Hi, > > On Sat, Apr 6, 2019 at 6:16 PM Urja Rannikko <urjaman@xxxxxxxxx> wrote: > > > > Hi, <snip> > > > > The difference would be in this format just setting hfront-porch = 87 > > and vback-porch = 14. > > Anyways the point is: I support moving this mode info into the dts, > > and I'd like to know how if at all should i go about getting a > > 60Hz(ish) mode upstreamed? > > I'm a bit torn here. I like the idea of actually getting 60 Hz and > you also increase the vblank time by a little bit (which means that if > anyone ever gets DDRFreq upstream it will work better). ...but I'm > also slightly nervous changing something like this without a really > good motivation. As you said in your commit message the pixels clocks > claimed by the spec don't actually all work and thus, to some extent, > we can only rely on trial-and-error here. While your new mode works > well on your device (and you wisely gave it a bit of margin), it is > _possible_ that there could be devices out there where it doesn't work > (especially across various temperature extremes). All devices were > tested in the factory with the old timings and presumably have been > running fine for years like that... Re: the trial and error: it might be the case that the panels actually work at 1506 vtotal if you also adjust the sync length and/or back porch "accordingly", whatever that accordingly would be for this panel since the datasheet doesnt tell. I missed this point when i was doing my testing and just adjusted the variables with the most "adjustability" (bigger starting value) to them. > I will certainly admit that it's unlikely devices would be affected, > but at the same time I'd want to know how much of a difference going > from 58.3 Hz to 60 Hz made for you. Could you actually notice any > visible difference, or was it just nice to be at 60 Hz? Honestly I was just doing this because i really liked the idea of actually making it 60Hz and my eyes arent that good at noticing high-fps things - i think the one case where it might be visible to a keen eye is 720p60 playback where you'd need to skip "about 2" (1.7..) frames a second if running at 58.3 Hz. But currently the C201 isnt doing a lot of that given i dont think i/we have a good software setup for it. That could be changing in the future with panfrost and the VPU hardware decoder support, etc. Anyways I'm thinking it would be prudent to first get this framework of device-tree modes in and then maybe adjust the mode later. Testing the 60Hz mode is simple enough: xrandr --newmode 1366x768p60 74.25 1366 1453 1483 1543 768 776 790 802 -HSync -VSync xrandr --addmode eDP-1 1366x768p60 xrandr --output eDP-1 --mode 1366x768p60 (The mode name can be anything...) So meanwhile I would appreciate it if we could get some test reports of the mode with other veyron chromebooks that have this panel :) -- Urja Rannikko
