Document the ramp-up and ramp-down property in the binding. Removing the "sec" from the property definition as seconds is implied. Signed-off-by: Dan Murphy <dmurphy@xxxxxx> --- v2 - Fixed commit message as this was not just a modification but adding documentation https://lore.kernel.org/patchwork/patch/1054504/ .../devicetree/bindings/mfd/ti-lmu.txt | 20 ++++++++++++------- 1 file changed, 13 insertions(+), 7 deletions(-) diff --git a/Documentation/devicetree/bindings/mfd/ti-lmu.txt b/Documentation/devicetree/bindings/mfd/ti-lmu.txt index 86ca786d54fc..adae96c79d39 100644 --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt @@ -25,6 +25,12 @@ Required properties: Optional property: - enable-gpios: A GPIO specifier for hardware enable pin. + - ramp-up-ms: Current ramping from one brightness level to + the a higher brightness level. + Range from 2048 us - 117.44 s + - ramp-down-ms: Current ramping from one brightness level to + the a lower brightness level. + Range from 2048 us - 117.44 s Required node: - backlight: All LMU devices have backlight child nodes. @@ -90,7 +96,7 @@ lm3631@29 { lcd_bl { led-sources = <0 1>; - ramp-up-msec = <300>; + ramp-up-ms = <300>; }; }; }; @@ -152,15 +158,15 @@ lm3633@36 { main { label = "main_lcd"; led-sources = <1 2>; - ramp-up-msec = <500>; - ramp-down-msec = <500>; + ramp-up-ms = <500>; + ramp-down-ms = <500>; }; front { label = "front_lcd"; led-sources = <0>; - ramp-up-msec = <1000>; - ramp-down-msec = <0>; + ramp-up-ms = <1000>; + ramp-down-ms = <0>; }; }; @@ -212,8 +218,8 @@ lm3697@36 { lcd { led-sources = <0 1 2>; - ramp-up-msec = <200>; - ramp-down-msec = <200>; + ramp-up-ms = <200>; + ramp-down-ms = <200>; }; }; -- 2.19.0
