From: Ludovic Barre <ludovic.barre@xxxxxx>
This patch defines get_dctrl_cfg callback for sdmmc variant.
sdmmc variant has specific stm32 transfer modes.
sdmmc data transfer mode selection could be:
-Block data transfer ending on block count.
-SDIO multibyte data transfer.
-MMC Stream data transfer (not used).
-Block data transfer ending with STOP_TRANSMISSION command.
Signed-off-by: Ludovic Barre <ludovic.barre@xxxxxx>
---
drivers/mmc/host/mmci.h | 5 +++++
drivers/mmc/host/mmci_stm32_sdmmc.c | 19 +++++++++++++++++++
2 files changed, 24 insertions(+)
diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h
index bfc6e54..4d33c4f 100644
--- a/drivers/mmc/host/mmci.h
+++ b/drivers/mmc/host/mmci.h
@@ -131,6 +131,11 @@
/* Control register extensions in the Qualcomm versions */
#define MCI_DPSM_QCOM_DATA_PEND BIT(17)
#define MCI_DPSM_QCOM_RX_DATA_PEND BIT(20)
+/* Control register extensions in STM32 versions */
+#define MCI_DPSM_STM32_MODE_BLOCK (0 << 2)
+#define MCI_DPSM_STM32_MODE_SDIO (1 << 2)
+#define MCI_DPSM_STM32_MODE_STREAM (2 << 2)
+#define MCI_DPSM_STM32_MODE_BLOCK_STOP (3 << 2)
#define MMCIDATACNT 0x030
#define MMCISTATUS 0x034
diff --git a/drivers/mmc/host/mmci_stm32_sdmmc.c b/drivers/mmc/host/mmci_stm32_sdmmc.c
index cfbfc6f..4c710e1 100644
--- a/drivers/mmc/host/mmci_stm32_sdmmc.c
+++ b/drivers/mmc/host/mmci_stm32_sdmmc.c
@@ -265,10 +265,29 @@ static void mmci_sdmmc_set_pwrreg(struct mmci_host *host, unsigned int pwr)
}
}
+static u32 sdmmc_get_dctrl_cfg(struct mmci_host *host)
+{
+ u32 datactrl;
+
+ datactrl = mmci_dctrl_blksz(host) | mmci_dctrl_dir(host);
+ datactrl |= mmci_dctrl_sdio(host) | mmci_dctrl_ddr(host);
+
+ if (host->mmc->card && mmc_card_sdio(host->mmc->card) &&
+ host->data->blocks == 1)
+ datactrl |= MCI_DPSM_STM32_MODE_SDIO;
+ else if (host->data->stop && !host->mrq->sbc)
+ datactrl |= MCI_DPSM_STM32_MODE_BLOCK_STOP;
+ else
+ datactrl |= MCI_DPSM_STM32_MODE_BLOCK;
+
+ return datactrl;
+}
+
static struct mmci_host_ops sdmmc_variant_ops = {
.validate_data = sdmmc_idma_validate_data,
.prep_data = sdmmc_idma_prep_data,
.unprep_data = sdmmc_idma_unprep_data,
+ .get_datactrl_cfg = sdmmc_get_dctrl_cfg,
.dma_setup = sdmmc_idma_setup,
.dma_start = sdmmc_idma_start,
.dma_finalize = sdmmc_idma_finalize,
--
2.7.4
