On Tue, Feb 19, 2019 at 04:19:20PM +0000, Piotr Sroka wrote:
> Signed-off-by: Piotr Sroka <piotrs@xxxxxxxxxxx>
> ---
> Changes for v2:
> - remove chip dependends parameters from dts bindings
> - add names for register ranges in dts bindings
> - add generic bindings to describe NAND chip representation
> under the NAND controller node
> ---
> .../bindings/mtd/cadence-nand-controller.txt | 48 ++++++++++++++++++++++
> 1 file changed, 48 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt
>
> diff --git a/Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt b/Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt
> new file mode 100644
> index 000000000000..3d9b4decae24
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/cadence-nand-controller.txt
> @@ -0,0 +1,48 @@
> +* Cadence NAND controller
> +
> +Required properties:
> + - compatible : "cdns,hpnfc"
Only one version of IP or is that discoverable?
> + - reg : Contains two entries, each of which is a tuple consisting of a
> + physical address and length. The first entry is the address and
> + length of the controller register set. The second entry is the
> + address and length of the Slave DMA data port.
> + - reg-names: should contain "cadence_reg" and "cadence_sdma"
'cadence_' part is pointless.
> + - interrupts : The interrupt number.
> + - clocks: phandle of the controller core clock (nf_clk).
> + - Children nodes represent the available NAND chips.
Need a blank line and remove the '-' as it's not a property.
> +
> +Required properties of NAND chips:
> + - reg: shall contain the native Chip Select ids from 0 to max supported by
> + the cadence nand flash controller
> +
> +Optional properties:
For child nodes? If not move before child nodes.
> + - dmas: shall reference DMA channel associated to the NAND controller
> + - cdns,board-delay : Estimated Board delay. The value includes the total
> + round trip delay for the signals and is used for deciding on values
> + associated with data read capture. The example formula for SDR mode is
> + the following:
> + board_delay = RE#PAD_delay + PCB trace to device + PCB trace from device
> + + DQ PAD delay
Units? Use unit suffix as defined in property-units.txt.
> +
> +See Documentation/devicetree/bindings/mtd/nand.txt for more details on
> +generic bindings.
> +
> +Example:
> +
> +nand_controller: nand-controller @60000000 {
space ^
> + compatible = "cdns,hpnfc";
> + reg = <0x60000000 0x10000>, <0x80000000 0x10000>;
> + reg-names = "cadence_reg", "cadence_sdma";
> + clocks = <&nf_clk>;
> + cdns,board-delay = <4830>;
> + interrupts = <2 0>;
> + nand@0 {
> + reg = <0>;
> + label = "nand-1";
> + };
> + nand@1 {
> + reg = <1>;
> + label = "nand-2";
> + };
> +
> +};
> --
> 2.15.0
>
