Add the 0.8GHz and 1GHz opps. According to the datasheet: https://www.nxp.com/docs/en/data-sheet/IMX8MDQLQIEC.pdf section 3.1.3 Operating ranges. The 0.8GHz opp runs in nominal mode with the regulator set to 0.9V. The 1GHz runs in overdrive mode with the regulator set to 1V. Signed-off-by: Abel Vesa <abel.vesa@xxxxxxx> --- arch/arm64/boot/dts/freescale/imx8mq.dtsi | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi b/arch/arm64/boot/dts/freescale/imx8mq.dtsi index 1a89062..ebdec9e 100644 --- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi +++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi @@ -91,6 +91,7 @@ clocks = <&clk IMX8MQ_CLK_ARM>; enable-method = "psci"; next-level-cache = <&A53_L2>; + operating-points-v2 = <&a53_0_opp_table>; }; A53_1: cpu@1 { @@ -101,6 +102,7 @@ clocks = <&clk IMX8MQ_CLK_ARM>; enable-method = "psci"; next-level-cache = <&A53_L2>; + operating-points-v2 = <&a53_0_opp_table>; }; A53_2: cpu@2 { @@ -111,6 +113,7 @@ clocks = <&clk IMX8MQ_CLK_ARM>; enable-method = "psci"; next-level-cache = <&A53_L2>; + operating-points-v2 = <&a53_0_opp_table>; }; A53_3: cpu@3 { @@ -121,6 +124,7 @@ clocks = <&clk IMX8MQ_CLK_ARM>; enable-method = "psci"; next-level-cache = <&A53_L2>; + operating-points-v2 = <&a53_0_opp_table>; }; A53_L2: l2-cache0 { @@ -666,6 +670,25 @@ status = "disabled"; }; + + a53_0_opp_table: opp-table { + compatible = "operating-points-v2"; + opp-shared; + + opp-800000000 { + opp-hz = /bits/ 64 <800000000>; + opp-microvolt = <900000>; + clock-latency-ns = <150000>; + }; + + opp-1000000000 { + opp-hz = /bits/ 64 <1000000000>; + opp-microvolt = <1000000>; + clock-latency-ns = <150000>; + opp-suspend; + }; + }; + gic: interrupt-controller@38800000 { compatible = "arm,gic-v3"; reg = <0x38800000 0x10000>, /* GIC Dist */ -- 2.7.4
