Add DT bindings document for Milbeaut clock.
Signed-off-by: Sugaya Taichi <sugaya.taichi@xxxxxxxxxxxxx>
---
.../devicetree/bindings/clock/milbeaut-clock.txt | 49 ++++++++++++++++++++++
1 file changed, 49 insertions(+)
create mode 100644 Documentation/devicetree/bindings/clock/milbeaut-clock.txt
diff --git a/Documentation/devicetree/bindings/clock/milbeaut-clock.txt b/Documentation/devicetree/bindings/clock/milbeaut-clock.txt
new file mode 100644
index 0000000..bcfc5df
--- /dev/null
+++ b/Documentation/devicetree/bindings/clock/milbeaut-clock.txt
@@ -0,0 +1,49 @@
+Milbeaut SoCs Clock Controller Binding
+----------------------------------------
+Milbeaut SoCs Clock controller is an integrated clock controller, which
+generates and supplies to all modules.
+
+This binding uses common clock bindings
+[1] Documentation/devicetree/bindings/clock/clock-bindings.txt
+
+Required properties:
+- compatible: should be one of the following:
+ "socionext,milbeaut-m10v-ccu" - for M10V SoC
+- reg: shall contain base address and length of clock registers
+- #clock-cells: shall be 1
+- clocks: shall be an external clock
+
+Example: Clock controller node:
+
+ clk: m10v-clk-ctrl@1d021000 {
+ compatible = "socionext,milbeaut-m10v-clk-ccu";
+ reg = <0x1d021000 0x4000>;
+ #clock-cells = <1>
+ clocks = <&clki40mhz>
+ };
+
+Example: Required an external clock for Clock controller node:
+
+ clocks {
+ clki40mhz: clki40mhz {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <40000000>;
+ };
+
+ /* other clocks */
+ };
+
+The clock consumer shall specify the desired clock-output of the clock
+controller as below by specifying output-id in its "clk" phandle cell.
+2: uart
+4: 32-bit timer
+
+Example: uart1 node:
+ uart1: serial@1e700010 {
+ compatible = "socionext,milbeaut-usio-uart";
+ reg = <0x1e700010 0x10>;
+ interrupts = <0 141 0x4>, <0 149 0x4>;
+ interrupt-names = "rx", "tx";
+ clocks = <&clk 2>;
+ };
--
1.9.1
