On Thu, Jan 31, 2019 at 01:29:40PM +0100, Claudiu Beznea - M18063 wrote: > From: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx> > > Add device tree binding for SAM9X60 pin controller. > > Signed-off-by: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx> > --- > Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 5 +++-- > 1 file changed, 3 insertions(+), 2 deletions(-) > > diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt > index 40e33dfc36fd..c2d51ed86d47 100644 > --- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt > +++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt > @@ -19,7 +19,7 @@ such as pull-up, multi drive, etc. > > Required properties for iomux controller: > - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl" > - or "atmel,sama5d3-pinctrl" > + or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pictrl" Typo s/microchip,sam9x60-pictrl/microchip,sam9x60-pinctrl > - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be > configured in this periph mode. All the periph and bank need to be describe. > > @@ -117,7 +117,8 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: > 4. The gpio controller must be describe in the pinctrl simple-bus. > > For each bank the required properties are: > -- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" > +- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or > + "microchip,sam9x60-gpio" > - reg: physical base address and length of the controller's registers > - interrupts: interrupt outputs from the controller > - interrupt-controller: marks the device node as an interrupt controller > -- > 2.7.4 >
