From: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx> Add device tree binding for SAM9X60 pin controller. Signed-off-by: Claudiu Beznea <claudiu.beznea@xxxxxxxxxxxxx> --- Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt index 40e33dfc36fd..c2d51ed86d47 100644 --- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt @@ -19,7 +19,7 @@ such as pull-up, multi drive, etc. Required properties for iomux controller: - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl" - or "atmel,sama5d3-pinctrl" + or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pictrl" - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be configured in this periph mode. All the periph and bank need to be describe. @@ -117,7 +117,8 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: 4. The gpio controller must be describe in the pinctrl simple-bus. For each bank the required properties are: -- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" +- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or + "microchip,sam9x60-gpio" - reg: physical base address and length of the controller's registers - interrupts: interrupt outputs from the controller - interrupt-controller: marks the device node as an interrupt controller -- 2.7.4
