Hi Wolfram, Just want to check if you had a chance to review the following patch series? Thanks, Ray On 1/20/2019 1:49 PM, Ray Jui wrote: > Hi Rayagonda/Wolfram, > > I reviewed the entire patch series and added my Reviewed-by tag on 1/8 > and 2/8. The rest of the patches in this series already had my > Signed-off-by tag. > > Thanks, > > Ray > > On 1/17/2019 10:04 PM, Rayagonda Kokatanur wrote: >> Hi, >> This patchset contains support for IPROC I2C slave and NIC I2C support. >> Following are the brief changes done inorder to support both IPROC I2C >> slave mode and NIC I2C, >> >> a. Add support to allow I2C rx transfer upto 255 bytes >> b. Add polling mode support to the iProc I2C driver. Polling mode is used >> in certain SoCs where interrupt is not connected from the I2C block. >> c. Add warpper read/write access for register to support indirect register >> access. This is required in certain SoCs with this iProc I2C >> block registered. >> d. Remove the set RESET bit to LOW right after setting it to HIGH so that >> wait duration can be met. >> >> This patch series is based on kernel v5.0.0-rc2. >> >> Changes from v2: >> - Address Ray's review comments. >> >> Changes from v1: >> - Rebased to Linux v5.0.0-rc2 >> >> Ray Jui (1): >> dt-bindings: i2c: iproc: make 'interrupts' optional >> >> Rayagonda Kokatanur (5): >> i2c: iproc: add polling support >> i2c: iproc: use wrapper for read/write access >> dt-bindings: i2c: iproc: add "brcm,iproc-nic-i2c" compatible string >> i2c: iproc: add NIC I2C support >> arm64: dts: Stingray: Add NIC i2c device node >> >> Shreesha Rajashekar (2): >> i2c: iproc: I2C read up to 255 bytes support >> i2c: iproc: Add Slave mode support >> >> .../devicetree/bindings/i2c/brcm,iproc-i2c.txt | 14 +- >> .../arm64/boot/dts/broadcom/stingray/stingray.dtsi | 18 + >> drivers/i2c/busses/Kconfig | 1 + >> drivers/i2c/busses/i2c-bcm-iproc.c | 757 +++++++++++++++++---- >> 4 files changed, 659 insertions(+), 131 deletions(-) >>
