On 25.01.2019 11:18, Thierry Reding wrote:
> From: Thierry Reding <treding@xxxxxxxxxx>
>
> If the system was booted using a device tree and if the device tree
> contains a MAC address, use it instead of reading one from the EEPROM.
> This is useful in situations where the EEPROM isn't properly programmed
> or where the firmware wants to override the existing MAC address.
>
I rarely see DT-configured boards with RTL8168 network. Do you add this
patch because of a specific board?
And you state "if EEPROM isn't properly programmed": Did you come across
such a case?
In general the patch is fine with me, I just want to understand the
motivation. One further comment see inline.
As of today we already have the option to set a MAC from userspace
via ethtool.
> Signed-off-by: Thierry Reding <treding@xxxxxxxxxx>
> ---
> Based on net-next.
>
> drivers/net/ethernet/realtek/r8169.c | 35 +++++++++++++++++-----------
> 1 file changed, 22 insertions(+), 13 deletions(-)
>
> diff --git a/drivers/net/ethernet/realtek/r8169.c b/drivers/net/ethernet/realtek/r8169.c
> index f574b6b557f9..fd9edd643ca5 100644
> --- a/drivers/net/ethernet/realtek/r8169.c
> +++ b/drivers/net/ethernet/realtek/r8169.c
> @@ -6957,6 +6957,21 @@ static int rtl_alloc_irq(struct rtl8169_private *tp)
> return pci_alloc_irq_vectors(tp->pci_dev, 1, 1, flags);
> }
>
[...]
> @@ -7252,20 +7268,13 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
> u64_stats_init(&tp->rx_stats.syncp);
> u64_stats_init(&tp->tx_stats.syncp);
>
> - /* Get MAC address */
> - switch (tp->mac_version) {
> - u8 mac_addr[ETH_ALEN] __aligned(4);
> - case RTL_GIGA_MAC_VER_35 ... RTL_GIGA_MAC_VER_38:
> - case RTL_GIGA_MAC_VER_40 ... RTL_GIGA_MAC_VER_51:
> - *(u32 *)&mac_addr[0] = rtl_eri_read(tp, 0xe0, ERIAR_EXGMAC);
> - *(u16 *)&mac_addr[4] = rtl_eri_read(tp, 0xe4, ERIAR_EXGMAC);
> + /* get MAC address */
> + if (eth_platform_get_mac_address(&pdev->dev, mac_addr))
> + rtl_read_mac_address(tp, mac_addr);
> +
> + if (is_valid_ether_addr(mac_addr))
Here array mac_addr may be uninitialized (if platform defines no MAC
and chip version is not covered by the switch statement).
> + rtl_rar_set(tp, mac_addr);
>
> - if (is_valid_ether_addr(mac_addr))
> - rtl_rar_set(tp, mac_addr);
> - break;
> - default:
> - break;
> - }
> for (i = 0; i < ETH_ALEN; i++)
> dev->dev_addr[i] = RTL_R8(tp, MAC0 + i);
>
>
