Add interrupt controller properties now that spmi-gpio is a proper hierarchical IRQ chip. The interrupts property is no longer needed so remove it. This change was not tested on any hardware but the same change was tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with no issues. Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx> --- This is a new patch introduced in V4. arch/arm64/boot/dts/qcom/pmi8994.dtsi | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/pmi8994.dtsi b/arch/arm64/boot/dts/qcom/pmi8994.dtsi index dae1cdc23f54..3aee10e3f921 100644 --- a/arch/arm64/boot/dts/qcom/pmi8994.dtsi +++ b/arch/arm64/boot/dts/qcom/pmi8994.dtsi @@ -15,16 +15,8 @@ reg = <0xc000>; gpio-controller; #gpio-cells = <2>; - interrupts = <2 0xc0 0 IRQ_TYPE_NONE>, - <2 0xc1 0 IRQ_TYPE_NONE>, - <2 0xc2 0 IRQ_TYPE_NONE>, - <2 0xc3 0 IRQ_TYPE_NONE>, - <2 0xc4 0 IRQ_TYPE_NONE>, - <2 0xc5 0 IRQ_TYPE_NONE>, - <2 0xc6 0 IRQ_TYPE_NONE>, - <2 0xc7 0 IRQ_TYPE_NONE>, - <2 0xc8 0 IRQ_TYPE_NONE>, - <2 0xc9 0 IRQ_TYPE_NONE>; + interrupt-controller; + #interrupt-cells = <2>; }; }; -- 2.17.2
