This patch adds a DT binding documentation for
Cadence GPIO controller.
Signed-off-by: Jan Kotas <jank@xxxxxxxxxxx>
---
.../devicetree/bindings/gpio/cdns,gpio.txt | 44 ++++++++++++++++++++++
1 file changed, 44 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpio/cdns,gpio.txt
diff --git a/Documentation/devicetree/bindings/gpio/cdns,gpio.txt b/Documentation/devicetree/bindings/gpio/cdns,gpio.txt
new file mode 100644
index 000000000..c87a47827
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/cdns,gpio.txt
@@ -0,0 +1,44 @@
+Cadence GPIO controller bindings
+
+Required properties:
+- compatible: should be "cdns,gpio-r1p02".
+- reg: the register base address and size.
+- #gpio-cells: should be 2.
+ * first cell is the GPIO number.
+ * second cell specifies the GPIO flags, as defined in
+ <dt-bindings/gpio/gpio.h>. Only the GPIO_ACTIVE_HIGH
+ and GPIO_ACTIVE_LOW flags are supported.
+- gpio-controller: marks the device as a GPIO controller.
+- clocks: should contain one entry referencing the peripheral clock driving
+ the GPIO controller.
+
+Optional properties:
+- ngpios: integer number of gpio lines supported by this controller, up to 32.
+- interrupt-parent: phandle of the parent interrupt controller.
+- interrupts: interrupt specifier for the controllers interrupt.
+- interrupt-controller: marks the device as an interrupt controller. When
+ defined, interrupts, interrupt-parent and #interrupt-cells
+ are required.
+- interrupt-cells: should be 2.
+ * first cell is the GPIO number you want to use as an IRQ source.
+ * second cell specifies the IRQ type, as defined in
+ <dt-bindings/interrupt-controller/irq.h>.
+ Currently only level sensitive IRQs are supported.
+
+
+Example:
+ gpio0: gpio-controller@fd060000 {
+ compatible = "cdns,gpio-r1p02";
+ reg =<0xfd060000 0x1000>;
+
+ clocks = <&gpio_clk>;
+
+ interrupt-parent = <&gic>;
+ interrupts = <0 5 IRQ_TYPE_LEVEL_HIGH>;
+
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
--
2.15.0
