v4 adds the system-power-controller node to the binding as requested
by Stefan. No driver changes are added to make the power controller
behavior optional yet, since it's really unrelated to this series.
Eric Anholt (5):
dt-bindings: soc: Add a new binding for the BCM2835 PM node. (v4)
bcm2835-pm: Move bcm2835-watchdog's DT probe to an MFD.
soc: bcm: bcm2835-pm: Add support for power domains under a new
binding.
ARM: bcm283x: Extend the WDT DT node out to cover the whole PM block.
(v4)
ARM: bcm283x: Switch V3D over to using the PM driver instead of
firmware.
.../bindings/soc/bcm/brcm,bcm2835-pm.txt | 46 ++
arch/arm/boot/dts/bcm2835-rpi.dtsi | 4 -
arch/arm/boot/dts/bcm283x.dtsi | 17 +-
arch/arm/mach-bcm/Kconfig | 1 +
drivers/mfd/Makefile | 1 +
drivers/mfd/bcm2835-pm.c | 92 +++
drivers/soc/bcm/Kconfig | 11 +
drivers/soc/bcm/Makefile | 1 +
drivers/soc/bcm/bcm2835-power.c | 661 ++++++++++++++++++
drivers/watchdog/bcm2835_wdt.c | 26 +-
include/dt-bindings/soc/bcm2835-pm.h | 28 +
include/linux/mfd/bcm2835-pm.h | 14 +
12 files changed, 878 insertions(+), 24 deletions(-)
create mode 100644 Documentation/devicetree/bindings/soc/bcm/brcm,bcm2835-pm.txt
create mode 100644 drivers/mfd/bcm2835-pm.c
create mode 100644 drivers/soc/bcm/bcm2835-power.c
create mode 100644 include/dt-bindings/soc/bcm2835-pm.h
create mode 100644 include/linux/mfd/bcm2835-pm.h
--
2.20.0.rc1
