[PATCH 9/9] arm64: dts: allwinner: a64-amarula-relic: Add GT5663 CTP node

[Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx>]

Add Goodix GT5663 capacitive touch controller node on
Amarula A64-Relic board.

The CTP connected to board with,
- SDA, SCK from i2c1
- GPIO-LD0 as vcc supply
- PH4 gpio as interrupt pin
- PH8 gpio as reset pin
- X and Y axis are inverted

Signed-off-by: Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx>
---
 .../allwinner/sun50i-a64-amarula-relic.dts    | 29 +++++++++++++++++++
 1 file changed, 29 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
index 9ac6d773188b..913fcdff828e 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
@@ -88,6 +88,28 @@
 	status = "okay";
 };
 
+&i2c1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&i2c1_pins>;
+	status = "okay";
+
+	touchscreen@5d {
+		compatible = "goodix,gt5663";
+		reg = <0x5d>;
+		vcc-supply = <&reg_ldo_io0>;			/* VCC-CTP: GPIO0-LDO */
+		interrupt-parent = <&pio>;
+		interrupts = <7 4 IRQ_TYPE_EDGE_FALLING>;
+		irq-gpios = <&pio 7 4 GPIO_ACTIVE_HIGH>;	/* CTP-INT: PH4 */
+		reset-gpios = <&pio 7 8 GPIO_ACTIVE_HIGH>;	/* CTP-RST: PH8 */
+		touchscreen-inverted-x;
+		touchscreen-inverted-y;
+	};
+};
+
+&i2c1_pins {
+	bias-pull-up;
+};
+
 &mmc1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc1_pins>;
@@ -251,6 +273,13 @@
 	regulator-name = "vdd-cpus";
 };
 
+&reg_ldo_io0 {
+	regulator-min-microvolt = <3300000>;
+	regulator-max-microvolt = <3300000>;
+	regulator-name = "vcc-ctp";
+	status = "okay";
+};
+
 &reg_rtc_ldo {
 	regulator-name = "vcc-rtc";
 };
-- 
2.18.0.321.gffc6fa0e3