The thermal IP can produce interrupts on overheat situation.
Describe them.
Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
---
.../bindings/arm/marvell/ap806-system-controller.txt | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt b/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt
index 3fd21bb7cb37..35e8dd2edfd2 100644
--- a/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt
+++ b/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt
@@ -114,12 +114,18 @@ Documentation/devicetree/bindings/thermal/thermal.txt
The thermal IP can probe the temperature all around the processor. It
may feature several channels, each of them wired to one sensor.
+It is possible to setup an overheat interrupt by giving at least one
+critical point to any subnode of the thermal-zone node.
+
Required properties:
- compatible: must be one of:
* marvell,armada-ap806-thermal
- reg: register range associated with the thermal functions.
Optional properties:
+- interrupt-parent/interrupts: overheat interrupt handle. Should point to
+ line 18 of the SEI irqchip.
+ See interrupt-controller/interrupts.txt
- #thermal-sensor-cells: shall be <1> when thermal-zones subnodes refer
to this IP and represents the channel ID. There is one sensor per
channel. O refers to the thermal IP internal channel, while positive
@@ -133,6 +139,8 @@ ap_syscon1: system-controller@6f8000 {
ap_thermal: thermal-sensor@80 {
compatible = "marvell,armada-ap806-thermal";
reg = <0x80 0x10>;
+ interrupt-parent = <&sei>;
+ interrupts = <18>;
#thermal-sensor-cells = <1>;
};
};
--
2.19.1
