The series adds support for the BL035-RGB-002 LCD panel and the required device-tree bindings for using it on the BananaPi M1. Only the changes related to the DRM driver and the panel are submitted for merge, which does not include the two final commits. Changes since v1: * Used the full name of the panel for dt bindings; * Removed helper to match flags in order to only retrieve the connector once, as it was already done. * Made the bus flags checking possible without a panel; Paul Kocialkowski (7): drm/sun4i: tcon: Pass encoder instead of using panel for RGB setup drm/sun4i: tcon: Support an active-low DE signal with RGB interface dt-bindings: Add vendor prefix for LeMaker dt-bindings: Add bindings for the LeMaker BL035-RGB-002 LCD panel drm/panel: simple: Add support for the LeMaker BL035-RGB-002 3.5" LCD ARM: dts: sun7i: Add pinmux configuration for LCD0 RGB888 pins ARM: dts: sun7i-a20-bananapi: Add bindings for the LeMaker 3.5" LCD .../display/panel/lemaker,bl035-rgb-002.txt | 7 ++ .../devicetree/bindings/vendor-prefixes.txt | 1 + arch/arm/boot/dts/sun7i-a20-bananapi.dts | 89 +++++++++++++++++++ arch/arm/boot/dts/sun7i-a20.dtsi | 11 +++ drivers/gpu/drm/panel/panel-simple.c | 27 ++++++ drivers/gpu/drm/sun4i/sun4i_tcon.c | 29 +++--- drivers/gpu/drm/sun4i/sun4i_tcon.h | 1 + 7 files changed, 151 insertions(+), 14 deletions(-) create mode 100644 Documentation/devicetree/bindings/display/panel/lemaker,bl035-rgb-002.txt -- 2.19.1
