Add OF match table for pci-rcar-gen2 driver for device tree support.
Signed-off-by: Ben Dooks <ben.dooks@xxxxxxxxxxxxxxx>
---
Updates since v1:
- moved documentation into patch
- moved to using bus-range parsing
- ensured usb phy can be linked to usb devices
Cc: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
Cc: Simon Horman <horms@xxxxxxxxxxxx>
Cc: linux-pci@xxxxxxxxxxxxxxx
Cc: linux-sh@xxxxxxxxxxxxxxx
Cc: devicetree@xxxxxxxxxxxxxxx
---
.../bindings/pci/renessas,pci-rcar-gen2.txt | 52 ++++++++++++++++++++++
drivers/pci/host/pci-rcar-gen2.c | 33 +++++++++++++-
2 files changed, 83 insertions(+), 2 deletions(-)
create mode 100644 Documentation/devicetree/bindings/pci/renessas,pci-rcar-gen2.txt
diff --git a/Documentation/devicetree/bindings/pci/renessas,pci-rcar-gen2.txt b/Documentation/devicetree/bindings/pci/renessas,pci-rcar-gen2.txt
new file mode 100644
index 0000000..bd6d291
--- /dev/null
+++ b/Documentation/devicetree/bindings/pci/renessas,pci-rcar-gen2.txt
@@ -0,0 +1,52 @@
+Renesas AHB to PCI bridge
+-------------------------
+
+This is the bridge used internally to connect the USB controllers to the
+AHB. There is one bridge instance per USB port consiting of an internal
+OHCI and EHCI controller.
+
+Required properties:
+ - compatible: "renesas,pci-r8a7790" for the R8A7790 SoC
+ - reg : A list of physical regions to access the device. The first is
+ the operational registers for the OHCI/EHCI controller and the
+ second region is for the bridge configuration and control registers.
+ - interrupts : interrupt for the device
+ - clocks : The reference to the device clock
+ - bus-range: The PCI bus number ranges. As this is a single bus, the range
+ should be specified as the same value twice.
+
+
+Example SoC configuration:
+
+ pci0: pci@ee090000 {
+ compatible = "renesas,pci-r8a7790";
+ clocks = <&mstp7_clks R8A7790_CLK_EHCI>;
+ reg = <0x0 0xee090000 0x0 0xc00>,
+ <0x0 0xee080000 0x0 0x1100>;
+ interrupts = <0 108 IRQ_TYPE_LEVEL_HIGH>;
+ status = "disabled";
+
+ bus-range = <0 0>;
+ #address-cells = <3>;
+ #size-cells = <2>;
+ };
+
+Example board setup:
+
+&pci1 {
+ status = "okay";
+ pinctrl-0 = <&usb1_pins>;
+ pinctrl-names = "default";
+
+ pci@0,1 {
+ reg = <0x800 0 0 0 0>;
+ device_type = "pci";
+ usb-phy = <&usbphy>;
+ };
+
+ pci@0,2 {
+ reg = <0x1000 0 0 0 0>;
+ device_type = "pci";
+ usb-phy = <&usbphy>;
+ };
+};
diff --git a/drivers/pci/host/pci-rcar-gen2.c b/drivers/pci/host/pci-rcar-gen2.c
index fd3e3ab..1216784 100644
--- a/drivers/pci/host/pci-rcar-gen2.c
+++ b/drivers/pci/host/pci-rcar-gen2.c
@@ -16,6 +16,7 @@
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
+#include <linux/of_pci.h>
#include <linux/platform_device.h>
#include <linux/pm_runtime.h>
#include <linux/sizes.h>
@@ -98,6 +99,7 @@ struct rcar_pci_priv {
struct resource io_res;
struct resource mem_res;
struct resource *cfg_res;
+ unsigned busnr;
int irq;
unsigned long window_size;
};
@@ -312,8 +314,8 @@ static int rcar_pci_setup(int nr, struct pci_sys_data *sys)
pci_add_resource(&sys->resources, &priv->io_res);
pci_add_resource(&sys->resources, &priv->mem_res);
- /* Setup bus number based on platform device id */
- sys->busnr = to_platform_device(priv->dev)->id;
+ /* Setup bus number based on platform device id / of bus-range */
+ sys->busnr = priv->busnr;
return 1;
}
@@ -366,6 +368,23 @@ static int rcar_pci_probe(struct platform_device *pdev)
priv->window_size = SZ_1G;
+ if (pdev->dev.of_node) {
+ struct resource busnr;
+ int ret;
+
+ ret = of_pci_parse_bus_range(pdev->dev.of_node, &busnr);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "failed to parse bus-range\n");
+ return ret;
+ }
+
+ priv->busnr = busnr.start;
+ if (busnr.end != busnr.start)
+ dev_warn(&pdev->dev, "only one bus number supported\n");
+ } else {
+ priv->busnr = pdev->id;
+ }
+
hw_private[0] = priv;
memset(&hw, 0, sizeof(hw));
hw.nr_controllers = ARRAY_SIZE(hw_private);
@@ -377,11 +396,21 @@ static int rcar_pci_probe(struct platform_device *pdev)
return 0;
}
+#ifdef CONFIG_OF
+static struct of_device_id rcar_pci_of_match[] = {
+ { .compatible = "renesas,pci-r8a7790", },
+ { },
+};
+
+MODULE_DEVICE_TABLE(of, rcar_pci_of_match);
+#endif
+
static struct platform_driver rcar_pci_driver = {
.driver = {
.name = "pci-rcar-gen2",
.owner = THIS_MODULE,
.suppress_bind_attrs = true,
+ .of_match_table = of_match_ptr(rcar_pci_of_match),
},
.probe = rcar_pci_probe,
};
--
1.9.0
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
