On the D3 and E3 SoCs, the LVDS encoder can derive its internal pixel clock from an externally supplied clock, either through the EXTAL pin or through one of the DU_DOTCLKINx pins. Add corresponding clocks to the DT bindings. To retain backward compatibility with DT that don't specify the clock-names property, the functional clock must always be specified first, and the clock-names property is optional when only the functional clock is specified. Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@xxxxxxxxxxxxxxxx> --- .../devicetree/bindings/display/bridge/renesas,lvds.txt | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/display/bridge/renesas,lvds.txt b/Documentation/devicetree/bindings/display/bridge/renesas,lvds.txt index 13af7e2ac7e8..9e3913f6a643 100644 --- a/Documentation/devicetree/bindings/display/bridge/renesas,lvds.txt +++ b/Documentation/devicetree/bindings/display/bridge/renesas,lvds.txt @@ -19,7 +19,17 @@ Required properties: - "renesas,r8a77995-lvds" for R8A77995 (R-Car D3) compatible LVDS encoders - reg: Base address and length for the memory-mapped registers -- clocks: A phandle + clock-specifier pair for the functional clock +- clocks: A list of phandles + clock-specifier pairs, one for each entry in + the clock-names property. +- clock-names: Name of the clocks. This property is model-dependent. + - The functional clock is mandatory for all models, shall be listed first, + and shall be named "fck". + - On R8A77990 and R8A77995, the LVDS encoder can use the EXTAL or + DU_DOTCLKINx clocks. Those clocks are optional. When supplied they must be + named "extal" and "dclkin.x" respectively, with "x" being the DU_DOTCLKIN + numerical index. + - When the clocks property only contains the functional clock, the + clock-names property may be omitted. - resets: A phandle + reset specifier for the module reset Required nodes: -- Regards, Laurent Pinchart
