Document the Broadcom roboswitch Switch Register Access Block interrupt
lines and additional register base addresses for port mux configuration
and SGMII status/configuration registers.
Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
.../devicetree/bindings/net/dsa/b53.txt | 36 +++++++++++++++++++
1 file changed, 36 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/dsa/b53.txt b/Documentation/devicetree/bindings/net/dsa/b53.txt
index 1811e1972a7a..5201bc15fdd6 100644
--- a/Documentation/devicetree/bindings/net/dsa/b53.txt
+++ b/Documentation/devicetree/bindings/net/dsa/b53.txt
@@ -46,6 +46,42 @@ Required properties:
"brcm,bcm6328-switch"
"brcm,bcm6368-switch" and the mandatory "brcm,bcm63xx-switch"
+Required properties for BCM585xx/586xx/88312 SoCs:
+
+ - reg: a total of 3 register base addresses, the first one must be the
+ Switch Register Access block base, the second is the port 5/4 mux
+ configuration register and the third one is the SGMII configuration
+ and status register base address.
+
+ - interrupts: a total of 13 interrupts must be specified, in the following
+ order: port 0-5, 7-8 link status change, then the integrated PHY interrupt,
+ then the timestamping interrupt and the sleep timer interrupts for ports
+ 5,7,8.
+
+Optional properties for BCM585xx/586xx/88312 SoCs:
+
+ - reg-names: a total of 3 names matching the 3 base register address, must
+ be in the following order:
+ "srab"
+ "mux_config"
+ "sgmii_config"
+
+ - interrupt-names: a total of 13 names matching the 13 interrupts specified
+ must be in the following order:
+ "link_state_p0"
+ "link_state_p1"
+ "link_state_p2"
+ "link_state_p3"
+ "link_state_p4"
+ "link_state_p5"
+ "link_state_p7"
+ "link_state_p8"
+ "phy"
+ "ts"
+ "imp_sleep_timer_p5"
+ "imp_sleep_timer_p7"
+ "imp_sleep_timer_p8"
+
See Documentation/devicetree/bindings/net/dsa/dsa.txt for a list of additional
required and optional properties.
--
2.17.1
