Apart from my two nitpicks, the whole series is Acked-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxxxxxxxxx> On 03/03/2014 at 11:05:53 +0100, Jean-Jacques Hiblot wrote : > This patch set aims at bringing a device tree support for the sam9261. > It's mostly based on the sam9263 and sam9x5 stuff. > > Changes since V4: > * change the compatibilty string for the bus matrix to > 'atmel,at91sam9260-bus-matrix' > * add a documentation for the bus matrix DT binding > * panic if the DT description of the bus matrix is not found > * Fixed the GPIO banks' address range > > Changes since V3: > * Added support for the touchscreen > * Added support for the spi dataflash > * Activated the TCB by default > * Reworked the patch organization to reduce the number of patchs > * changed the default bootargs (no mem description, UBI on mtdpart 5) > * Changed the xlate implementation of the at91 pinctrl driver to lock the GPIOs > for IRQs instead of requesting them (needed for the touchscreen driver) > * some stylistic changes > > Changes since V2: > * removed the smc driver from the serie. It'll be posted in an independent > serie later. > * removed the DM9000 support (it'll come with the smc driver) > * the sam9261 now supports the Common Clock Framework (CCF). Note: to enable > the CCF you must remove from the kernel config the platforms that don't > support it. > * Added basic DT binding for the bus matrix > * Added support for USB host > * Added support for USB gadget > * in dts(i), replaced interrupt-parent with interrupts-extended > * changed the nand partition plan (same as for the sama5d3) > * removed 'mem' parameter in command line > * re-ordered dt-nodes in ascending address order. > * split the lcd support patch in 2 parts (SOC and board) > > > Change since V1: > * changed the DT representation to use address translation and separate the > timings' configuration from the device properties by adding a "simple-bus" > inetrmediate node. > * moved the smc driver from drivers/bus to drivers/memmory > * smc driver now accepts timings in nanoseconds as well as raw register values > * smc driver can clip the timings if they're out of bound and dump them to the > console > * DM9000 timings are now described in nanosecs (for the virtue of example) > > supported features are: > * working with the Common Clock Framework and the old at91 clock implementation > * dbgu > * lcdc > * usb host > * usb gadget, > * spi dataflash > * nand flash > * touchscreen > * leds > * user buttons > > In the TODO list: > * dm9000 (ethernet) > * audio > * mmc > > This serie relies on the following patchs: > usb: at91-udc: fix irq and iomem resource retrieval > ARM: at91: prepare sam9 dt boards transition to common > > Jean-Jacques > > Jean-Jacques Hiblot (9): > at91: dt: Adds support for the bus matrix declaration in the DT > dt: bindings: at91: Add a new binding for the bus matrix > at91: pinctrl: don't request GPIOs used for interrupts but lock them > as IRQ > at91: dt: Add at91sam9261 dt SoC support > at91: dt: defconfig: Added the sam9261 to the list of DT-enabled SOCs > at91: dt: sam9261: Device Tree support for the at91sam9261ek > at91: updated the at91_dt_defconfig with support for the ADS7846 > ARM: at91: prepare common clk transition for sam9261 SoC > ARM: at91: move sam9261 SoC to common clk > > .../devicetree/bindings/arm/atmel-at91.txt | 14 + > arch/arm/boot/dts/Makefile | 2 + > arch/arm/boot/dts/at91sam9261.dtsi | 740 +++++++++++++++++++++ > arch/arm/boot/dts/at91sam9261ek.dts | 204 ++++++ > arch/arm/configs/at91_dt_defconfig | 2 + > arch/arm/mach-at91/Kconfig | 1 - > arch/arm/mach-at91/at91sam9261.c | 25 +- > arch/arm/mach-at91/setup.c | 21 + > drivers/pinctrl/pinctrl-at91.c | 5 +- > 9 files changed, 1008 insertions(+), 6 deletions(-) > create mode 100644 arch/arm/boot/dts/at91sam9261.dtsi > create mode 100644 arch/arm/boot/dts/at91sam9261ek.dts > > -- > 1.9.0 > -- Alexandre Belloni, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
