Dear Andreas,
I put the kernel support for the SX1276 LoRa chip in question. I don’t
think that this kind of device should be in the Linux kernel.
Here are a few facts to consider:
- A LoRa transaction is very slow (e.g. SF7 needs about 210 ms, for
SF12 6280 ms) for 12 bytes user data with acknowledge.
- There are many different implementations for the antenna switch,
switching between receiving/sending, PA-BOOST, 433, 868/915 MHz. (I know
SX1276 Heltec ESP32, SX1276 Murata, RFM95-(1276), SX1276 Heltec
STM32-L4) they are all different regarding this.
- The LoRa chip device ID is only 8-bit which is not sufficient for
larger networks, e.g. our RadioShuttle protocol uses compressed 32-bit
device IDs.
- The chip can do MTU sizes up to 2048 bytes, most protocols use less
than 250 bytes.
- Applications do on-the-fly channel and spreading factor switching
which makes it more difficult for the configuration.
- The chip supports Lora modulation as well as FSK, GFSK, MSK, GMSK,
and OOK modulation, for some use cases the other modulations are of
interest, e.g. to communicated with other devices.
- Power saving modes, like sleep, suspend may be required for battery
operation.
- Cad detection is very flexible and can be differently used.
- LoRa preamble may be different depending on the protocol used.
- The new Lora chip SX1262 / 68 (successor of the SX1276) has different
hardware and all different registers, it is driver incompatible with the
SX1276. It needs an entire new driver.
- The device is not multi-process capable (only a single process can
communicate with it).
- There are SX1276 LoRa modules with a build-in protocol (LoRaWAN and
RAW) via a serial connection only, again complete different API compared
the SX1276 chip. Software updates for this devices are difficult.
- I am even convinced that the LoRaWAN protocol with the concentrator
concept is not good, the peer to peer communication and a standard MQTT
gateway (what we do) is way more flexible.
For all this reasons, I feel a user level driver task implementation is
way more flexible. I did a lot of work/enhancements on the SX1276 link
level driver from Semtech, it is available and maintained on mbed.org
and supports mbed-os, Arduino and is prepared for Linux.
https://os.mbed.com/users/Helmut64/code/SX1276GenericLib/
Protocols e.g. our RadioShuttle LoRa peer to peer protocol or the
LoRaWAN protocol can run on top of the SX1276GenericLib. We may should
focus on such a driver library getting supported for multiple OS's (Win,
Linux, mbed, Ardino, etc.)
Again I feel a Linux kernel device driver for the SX1276 chip make
little sense for me.
Regards
Helmut Tschemernjak (www.radioshuttle.de, www.helios.de)
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
