Hi, Linus Anson Huang Best Regards! > -----Original Message----- > From: Linus Walleij [mailto:linus.walleij@xxxxxxxxxx] > Sent: Monday, July 2, 2018 9:46 PM > To: Anson Huang <anson.huang@xxxxxxx>; Fabio Estevam > <fabio.estevam@xxxxxxx> > Cc: Rob Herring <robh+dt@xxxxxxxxxx>; Mark Rutland > <mark.rutland@xxxxxxx>; open list:GPIO SUBSYSTEM > <linux-gpio@xxxxxxxxxxxxxxx>; open list:OPEN FIRMWARE AND FLATTENED > DEVICE TREE BINDINGS <devicetree@xxxxxxxxxxxxxxx>; > linux-kernel@xxxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx> > Subject: Re: [PATCH] bindings: add clocks optional binding for imx gpio > > On Fri, Jun 29, 2018 at 5:34 AM Anson Huang <Anson.Huang@xxxxxxx> > wrote: > > > Some i.MX SoCs have GPIO clock gate in CCM, accessing GPIO registers > > needs to enable GPIO clock gate first, i.MX GPIO driver will enable > > clock gate if there is clock property in GPIO node of dtb, add > > optional property to i.MX GPIO binding doc. > > > > Signed-off-by: Anson Huang <Anson.Huang@xxxxxxx> > > Make sense since the gpio-mxc driver already supports this :) > > > +Optional properties: > > +- clocks: the clocks used by gpio bank > > Should the text be "the clock for clocking the GPIO silicon" > I guess that is what it is. And singularis? Yes, it is singularis, I will improve the text. > > Does it hurt to give the clock a name? Like the common "pclk" for peripheral > clock or something similar that other i.MX silicon uses? It is just because GPIO only needs one clock, and the driver does NOT get the clock using clock name, so the GPIO node in dtb also has no clock name specified, if we add a clock name here, dtb also need to be updated? And I saw other i.MX modules which have only one clock, they also have no clock name specified, like I2C on i.MX6QDL, I will send a V2 patch with text improved, thanks. Anson. > > Fabio: can we have your ACK on this too. > > Yours, > Linus Walleij ��.n��������+%������w��{.n����z�{��ܨ}���Ơz�j:+v�����w����ޙ��&�)ߡ�a����z�ޗ���ݢj��w�f