On Friday 25 May 2018 11:51 PM, David Lechner wrote: > On 05/22/2018 04:38 AM, Sekhar Nori wrote: >> Hi David, >> >> On Friday 18 May 2018 10:18 PM, David Lechner wrote: >>> This series converts mach-davinci to use the common clock framework. >>> >>> The series works like this, the first 3 patches fix some issues with >>> the clock >>> drivers that have already been accepted into the mainline kernel. >>> >>> Then, starting with "ARM: davinci: pass clock as parameter to >>> davinci_timer_init()", we get the mach code ready for the switch by >>> adding the >>> code needed for the new clock drivers and adding #ifndef >>> CONFIG_COMMON_CLK >>> around the legacy clocks so that we can switch easily between the old >>> and the >>> new. >>> >>> "ARM: davinci: switch to common clock framework" actually flips the >>> switch >>> to start using the new clock drivers. Then the next 8 patches remove all >>> of the old clock code. >>> >>> The final four patches add device tree clock support to the one SoC that >>> supports it. >>> >>> This series has been tested on TI OMAP-L138 LCDK (both device tree >>> and legacy >>> board file). >> >> If you do end up sending a v12, you can leave out the mach-davinci >> portions unless there are any changes you need to make. I will pick them >> up from this series once the driver dependencies are merged. >> >> I do hope the drivers/clk/* changes can be merged from v4.18. >> > > I have resent all of the clk patches (including all of the ones I listed as > dependencies in addition to the three remaining in this series) under the > cover "clk: davinci: outstanding fixes". > > I also found that we need to add power-domains properties to the PWM nodes > in "ARM: dts: da850: Add clocks". I probably should just take your advice > and just globally added them even if they are not documented for some types > ofnodes. I think doing it en masse will be controversial. Just add it to PWM nodes for now (I am assuming the binding documentation agrees). I have applied this series so please send any more changes as follow-on patches. Thanks Sekhar -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
