Hi David, On Friday 18 May 2018 10:18 PM, David Lechner wrote: > This series converts mach-davinci to use the common clock framework. > > The series works like this, the first 3 patches fix some issues with the clock > drivers that have already been accepted into the mainline kernel. > > Then, starting with "ARM: davinci: pass clock as parameter to > davinci_timer_init()", we get the mach code ready for the switch by adding the > code needed for the new clock drivers and adding #ifndef CONFIG_COMMON_CLK > around the legacy clocks so that we can switch easily between the old and the > new. > > "ARM: davinci: switch to common clock framework" actually flips the switch > to start using the new clock drivers. Then the next 8 patches remove all > of the old clock code. > > The final four patches add device tree clock support to the one SoC that > supports it. > > This series has been tested on TI OMAP-L138 LCDK (both device tree and legacy > board file). If you do end up sending a v12, you can leave out the mach-davinci portions unless there are any changes you need to make. I will pick them up from this series once the driver dependencies are merged. I do hope the drivers/clk/* changes can be merged from v4.18. Thanks, Sekhar -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
