This adds support for the Zodiac Inflight Innovations SCU2 Ethernet
Switch Board, which is based on the i.MX51.
Signed-off-by: Andrey Gusakov <andrey.gusakov@xxxxxxxxxxxxxxxxxx>
---
arch/arm/boot/dts/Makefile | 3 +-
arch/arm/boot/dts/imx51-zii-scu2-esb.dts | 178 +++++++++++++++++++++++++++++++
2 files changed, 180 insertions(+), 1 deletion(-)
create mode 100644 arch/arm/boot/dts/imx51-zii-scu2-esb.dts
diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
index 37a3de7..d8900f4 100644
--- a/arch/arm/boot/dts/Makefile
+++ b/arch/arm/boot/dts/Makefile
@@ -358,7 +358,8 @@ dtb-$(CONFIG_SOC_IMX51) += \
imx51-digi-connectcore-jsk.dtb \
imx51-eukrea-mbimxsd51-baseboard.dtb \
imx51-ts4800.dtb \
- imx51-zii-rdu1.dtb
+ imx51-zii-rdu1.dtb \
+ imx51-zii-scu2-esb.dtb
dtb-$(CONFIG_SOC_IMX53) += \
imx53-ard.dtb \
imx53-cx9020.dtb \
diff --git a/arch/arm/boot/dts/imx51-zii-scu2-esb.dts b/arch/arm/boot/dts/imx51-zii-scu2-esb.dts
new file mode 100644
index 0000000..e052133
--- /dev/null
+++ b/arch/arm/boot/dts/imx51-zii-scu2-esb.dts
@@ -0,0 +1,178 @@
+// SPDX-License-Identifier: (GPL-2.0 OR MIT)
+// Copyright (C) 2018 Zodiac Inflight Innovations
+
+/dts-v1/;
+#include "imx51-zii-common.dtsi"
+
+/ {
+ model = "ZII SCU2 ESB board";
+ compatible = "zii,imx51-scu2-esb", "fsl,imx51";
+};
+
+&esdhc1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_esdhc1_4bit &pinctrl_esdhc1_8bit>;
+ bus-width = <8>;
+};
+
+&fec {
+ phy-reset-gpios = <&gpio4 21 GPIO_ACTIVE_LOW>;
+
+ fixed-link {
+ speed = <100>;
+ full-duplex;
+ };
+
+ fec_mdio: mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ status = "okay";
+
+ switch@0 {
+ compatible = "marvell,mv88e6085";
+ reg = <0>;
+ dsa,member = <0 0>;
+ eeprom-length = <512>;
+ interrupt-parent = <&gpio4>;
+ interrupts = <20 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+ label = "port1";
+ };
+
+ port@1 {
+ reg = <1>;
+ label = "port2";
+ };
+
+ port@2 {
+ reg = <2>;
+ label = "port3";
+ };
+
+ port@3 {
+ reg = <3>;
+ label = "scu2scu";
+ };
+
+ port@4 {
+ reg = <4>;
+ label = "esb2host";
+ };
+ port@5 {
+ reg = <5>;
+ label = "esb2mezz";
+ phy-mode = "sgmii";
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ };
+ };
+ port@6 {
+ reg = <6>;
+ label = "cpu";
+ phy-mode = "mii";
+ ethernet = <&fec>;
+
+ fixed-link {
+ speed = <100>;
+ full-duplex;
+ };
+ };
+ };
+ };
+ };
+};
+
+&i2c2 {
+ lm75@48 {
+ compatible = "national,lm75";
+ reg = <0x48>;
+ };
+};
+
+&i2c_gpio {
+ gpios = <&gpio3 1 GPIO_ACTIVE_HIGH>, /* sda */
+ <&gpio3 0 GPIO_ACTIVE_HIGH>; /* scl */
+};
+
+&ipu {
+ status = "disabled";
+};
+
+&usb_vbus {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_usb_mmc_reset>;
+ gpio = <&gpio4 19 GPIO_ACTIVE_LOW>;
+ startup-delay-us = <150000>;
+};
+
+&iomuxc {
+ pinctrl_fec: fecgrp {
+ fsl,pins = <
+ MX51_PAD_DISP2_DAT15__FEC_TDATA0 0x2004
+ MX51_PAD_DISP2_DAT6__FEC_TDATA1 0x2004
+ MX51_PAD_DISP2_DAT7__FEC_TDATA2 0x2004
+ MX51_PAD_DISP2_DAT8__FEC_TDATA3 0x2004
+ MX51_PAD_DISP2_DAT9__FEC_TX_EN 0x2004
+ MX51_PAD_DISP2_DAT10__FEC_COL 0x0180
+ MX51_PAD_DISP2_DAT11__FEC_RX_CLK 0x0180
+ MX51_PAD_DISP2_DAT12__FEC_RX_DV 0x20a4
+ MX51_PAD_DISP2_DAT13__FEC_TX_CLK 0x2180
+ MX51_PAD_DISP2_DAT14__FEC_RDATA0 0x2180
+ MX51_PAD_DI2_DISP_CLK__FEC_RDATA1 0x0085
+ MX51_PAD_DI_GP4__FEC_RDATA2 0x0085
+ MX51_PAD_DISP2_DAT0__FEC_RDATA3 0x0085
+ MX51_PAD_DI2_PIN2__FEC_MDC 0x2004
+ MX51_PAD_DI2_PIN3__FEC_MDIO 0x01f5
+ MX51_PAD_DI2_PIN4__FEC_CRS 0x0180
+ MX51_PAD_AUD3_BB_FS__GPIO4_21 0x0000
+ >;
+ };
+
+ pinctrl_swi2c: swi2cgrp {
+ fsl,pins = <
+ MX51_PAD_DI1_PIN11__GPIO3_0 0x100
+ MX51_PAD_DI1_PIN12__GPIO3_1 0x100
+ >;
+ };
+
+ pinctrl_uart1: uart1grp {
+ fsl,pins = <
+ MX51_PAD_UART1_RXD__UART1_RXD 0x1c5
+ MX51_PAD_UART1_TXD__UART1_TXD 0x1c5
+ MX51_PAD_UART1_RTS__UART1_RTS 0x1c5
+ MX51_PAD_UART1_CTS__UART1_CTS 0x1c5
+ >;
+ };
+
+ pinctrl_uart2: uart2grp {
+ fsl,pins = <
+ MX51_PAD_UART2_RXD__UART2_RXD 0x1c5
+ MX51_PAD_UART2_TXD__UART2_TXD 0x1c5
+ MX51_PAD_USBH1_DATA0__UART2_CTS 0x1c5
+ MX51_PAD_USBH1_DATA3__UART2_RTS 0x1c5
+ >;
+ };
+
+ pinctrl_uart3: uart3grp {
+ fsl,pins = <
+ MX51_PAD_UART3_RXD__UART3_RXD 0x1c5
+ MX51_PAD_UART3_TXD__UART3_TXD 0x1c5
+ >;
+ };
+
+ pinctrl_usb_mmc_reset: usbmmcgrp {
+ fsl,pins = <
+ MX51_PAD_AUD3_BB_RXD__GPIO4_19 0x100
+ >;
+ };
+};
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
