Hi Andy,
On Sun, Jun 03, 2018 at 11:37:53AM +0300, Andy Shevchenko wrote:
> On Sat, Jun 2, 2018 at 7:54 PM, Manivannan Sadhasivam
> <manivannan.sadhasivam@xxxxxxxxxx> wrote:
> > Add interrupt support for Actions Semi OWL S900 SoC.
>
> > + port = owl_gpio_get_port(pctrl, &gpio);
> > + if (WARN_ON(port == NULL))
> > + return;
>
> At which circumstances the above possible?
>
Only possible when the requested GPIO exceeds chip->ngpio. I know it is
a kind of redundant check, but it is good to have this during development.
> > + port = owl_gpio_get_port(pctrl, &gpio);
> > + if (WARN_ON(port == NULL))
> > + return;
>
> Ditto.
>
Same as above.
> > + port = owl_gpio_get_port(pctrl, &gpio);
> > + if (WARN_ON(port == NULL))
> > + return;
>
> Ditto.
>
Same as above.
> > + port = owl_gpio_get_port(pctrl, &gpio);
> > + if (WARN_ON(port == NULL))
> > + return -ENODEV;
>
> Ditto.
>
Same as above.
>
> > + for (i = 0; i < chip->ngpio; i++) {
> > + irqno = irq_create_mapping(pctrl->domain, i);
> > + irq_set_chip_and_handler(irqno, &owl_gpio_irq_chip,
> > + handle_edge_irq);
> > + irq_set_chip_data(irqno, pctrl);
> > + }
>
> I'm not sure the handle_edge_irq() is a correct handler here. It would
> be handle_bad_irq() until IRQ has been requested properly.
> No?
>
Hmmm, good question. Since the handler used in irq_set_chip_and_handler
is superseded by irq_set_chained_handler_and_data, this doesn't matter
anyway. But I would like to hear what Linus suggests here!
> > +/* GPIO TYPE Bit Definition */
> > +#define OWL_GPIO_INT_LEVEL_HIGH 0
> > +#define OWL_GPIO_INT_LEVEL_LOW 1
> > +#define OWL_GPIO_INT_EDGE_RISING 2
> > +#define OWL_GPIO_INT_EDGE_FALLING 3
>
> > +#define OWL_GPIO_INT_MASK 3
>
> GENMASK?
>
Ack.
Thanks,
Mani
> --
> With Best Regards,
> Andy Shevchenko
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
