Add usb otg support for bananapi-m64 board, - USB-ID connected with PH9 - USB-DRVVBUS controlled by N_VBUSEN pin from PMIC Signed-off-by: Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx> Reviewed-by: Chen-Yu Tsai <wens@xxxxxxxx> --- Changes for v6: - Rebase on master Changes for v5: - Kept reg_drivevbus node in alphabetical order. - Collect Chen-Yu reviewed-by tag Changes for v4: - rebase on master - tested otg host mode. Changes for v3: - Move the position of reg_drivevbus as per binding documentation. Changes for v2: - add drvvbus regulator - add N_VBUSEN pin .../boot/dts/allwinner/sun50i-a64-bananapi-m64.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-bananapi-m64.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-bananapi-m64.dts index 2250dec9974c..0716b1441187 100644 --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-bananapi-m64.dts +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-bananapi-m64.dts @@ -86,6 +86,10 @@ }; }; +&ehci0 { + status = "okay"; +}; + &ehci1 { status = "okay"; }; @@ -155,6 +159,10 @@ status = "okay"; }; +&ohci0 { + status = "okay"; +}; + &ohci1 { status = "okay"; }; @@ -167,6 +175,7 @@ reg = <0x3a3>; interrupt-parent = <&r_intc>; interrupts = <0 IRQ_TYPE_LEVEL_LOW>; + x-powers,drive-vbus-en; /* set N_VBUSEN as output pin */ }; }; @@ -254,6 +263,11 @@ regulator-name = "vcc-wifi-io"; }; +®_drivevbus { + regulator-name = "usb0-vbus"; + status = "okay"; +}; + ®_eldo1 { regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; @@ -294,6 +308,13 @@ status = "okay"; }; +&usb_otg { + dr_mode = "otg"; + status = "okay"; +}; + &usbphy { + usb0_id_det-gpios = <&pio 7 9 GPIO_ACTIVE_HIGH>; /* PH9 */ + usb0_vbus-supply = <®_drivevbus>; status = "okay"; }; -- 2.14.3 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html