The driver currently support only vlan priority zero. So map the
vlan priorities to zero flow in hardware.
Signed-off-by: Murali Karicheri <m-karicheri2@xxxxxx>
---
drivers/net/ethernet/ti/netcp_ethss.c | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/drivers/net/ethernet/ti/netcp_ethss.c b/drivers/net/ethernet/ti/netcp_ethss.c
index 83acb72..91935e5 100644
--- a/drivers/net/ethernet/ti/netcp_ethss.c
+++ b/drivers/net/ethernet/ti/netcp_ethss.c
@@ -602,6 +602,7 @@ struct gbe_port_regs {
struct gbe_port_regs_ofs {
u16 port_vlan;
u16 tx_pri_map;
+ u16 rx_pri_map;
u16 sa_lo;
u16 sa_hi;
u16 ts_ctl;
@@ -2304,6 +2305,13 @@ static int gbe_slave_open(struct gbe_intf *gbe_intf)
gbe_sgmii_rtreset(priv, slave, false);
gbe_port_config(priv, slave, priv->rx_packet_max);
gbe_set_slave_mac(slave, gbe_intf);
+ /* For NU & 2U switch, map the vlan priorities to zero
+ * as we only configure to use priority 0
+ */
+ if (IS_SS_ID_MU(priv))
+ writel(HOST_TX_PRI_MAP_DEFAULT,
+ GBE_REG_ADDR(slave, port_regs, rx_pri_map));
+
/* enable forwarding */
cpsw_ale_control_set(priv->ale, slave->port_num,
ALE_PORT_STATE, ALE_PORT_STATE_FORWARD);
@@ -3005,6 +3013,7 @@ static int init_slave(struct gbe_priv *gbe_dev, struct gbe_slave *slave,
/* Initialize slave port register offsets */
GBENU_SET_REG_OFS(slave, port_regs, port_vlan);
GBENU_SET_REG_OFS(slave, port_regs, tx_pri_map);
+ GBENU_SET_REG_OFS(slave, port_regs, rx_pri_map);
GBENU_SET_REG_OFS(slave, port_regs, sa_lo);
GBENU_SET_REG_OFS(slave, port_regs, sa_hi);
GBENU_SET_REG_OFS(slave, port_regs, ts_ctl);
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
