Hi Jacopo,
Thank you for the patch.
On Friday, 6 April 2018 16:08:10 EEST Jacopo Mondi wrote:
> Enable DU for Renesas R-Car V3M Eagle board.
>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/renesas/r8a77970-eagle.dts | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> b/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts index 3c5f598..144b847
> 100644
> --- a/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> +++ b/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> @@ -76,6 +76,11 @@
> function = "i2c0";
> };
>
> + du_pins: du {
> + groups = "du_rgb666", "du_sync", "du_oddf", "du_clk_out";
> + function = "du";
> + };
As far as I can tell the DU parallel output isn't used on the Eagle board, but
is used on the Eagle expansion board. I would move this to patch 7/7 in this
series.
> scif0_pins: scif0 {
> groups = "scif0_data";
> function = "scif0";
> @@ -93,3 +98,9 @@
>
> status = "okay";
> };
> +
> +&du {
> + pinctrl-0 = <&du_pins>;
> + pinctrl-names = "default";
These two properties should be moved to patch 7/7 too.
> + status = "okay";
> +};
There's little use for enabling the DU in DT if you have no output port
described. I'd move this to patch 6/7.
--
Regards,
Laurent Pinchart
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
