* Tony Lindgren <tony@xxxxxxxxxxx> [180402 15:59]: > * Dan Williams <dcbw@xxxxxxxxxx> [180402 15:51]: > > On Sun, 2018-04-01 at 10:30 -0700, Tony Lindgren wrote: > > > * Tony Lindgren <tony@xxxxxxxxxxx> [180401 15:38]: > > > Found it! Here's what I need to do over n_gsm: > > > > > > ngsm 1 "AT+CFUN=1" > > > ngsm 1 "AT+CFUN?" > > > ngsm 2 "AT+EACC=3,0" # enable mic > > > ngsm 2 "AT+CLVL=4" # set speaker volume > > > ngsm 2 "AT+CMUT=0" # unmute mic > > > > I tried to look through the QMI dumps we have in libqmi from 2013 > > (latest Qualcomm posted) and couldn't find anything to do with mic > > control, speaker volume, or anything like that. > > > > If the modem supports the AT service (which I think it does? Not > > looking at the libqmi dumps right now) then it could potentially tunnel > > these AT commands through QMI too. > > > > Perhaps Qualcomm added something to the Voice service after 2013, or > > perhaps there are other services that might control speaker/mic that we > > don't have public dumps for yet though. > > OK thanks for checking. So probably only n_gsm channel 1 is for normal > Qualcomm at commands, and then channel 2 and others are commands > implemented by Motorola on the mdm6600. > > I guess we'd have to add support for reading and writing to > /dev/gsmtty2 at least as it looks like these cannot be accessed > via /dev/ttyUSB4. Or at least I have not figured out any other > way to access them. Hmm or maybe there is some way to select where qmi to tunnels the AT commands to? Some kind of channel type paramenter like n_gsm has? Anyways, for trying to figure out things for alsamixer, I tested that ngsm 2 "AT+EACC=3,0" is not related to cpcap audio register settings and the mic is enabled during the call with Pavel's patch with alsamixer "Mode" set to either "Call" or "Normal". Also speaker keeps working during the call toggling between "Call" and "Normal". "Voice" in alsamixer does also control the speaker volume during the call. And setting the second "Speaker" from "Voice" to "HiFi" mutes the speaker. Then alsamixer capture settings for "Mic2" do change the mic gain as expected, and setting "Right" to "Off" mutes the mic. And then setting "Left" to "Mic 2" turns on the mic again. So my guess is that ngsm 2 "AT+EACC=3,0" and ngsm 2 "AT+CLVL=4" might control some external amp over the mdm6600 gpio pins? With "AT+CLVL" values being 0 7 it sounds like 3 gpios for that? Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
