* Pavel Machek <pavel@xxxxxx> [180331 19:56]: > On Sat 2018-03-31 21:46:16, Pavel Machek wrote: > > On Sat 2018-03-31 21:19:39, Pavel Machek wrote: > > > On Sat 2018-03-31 11:19:35, Tony Lindgren wrote: > > > > Cool :) Microphone still does not work for me.. I tried tweaking > > > > the alsamixer settings but no mic. This is with cold boot with > > > > droid4-kexecboot if that might make a difference, we may have > > > > some register uninitialized somewhere. Any ideas? > > > > > > Ok, I was focusing on the speaker side. > > > > > > alsamixer, tab to go to capture settings, set it to 37 37 Mic2 Mic1 > > > should work, according to my notes, but not recently tested and not > > > tested against real human. > > > > > > I'll attempt to test it, but something in my userland shuts down > > > system just after boot 60% of time, which is rather annoying. > > > > Hmm. So I tried again, and setting Mic1 and back in the capture > > settings crashed the modem. Bang, disconnected from the USB. > > Next try, and it worked this time. > > _Before the call_, set mode to Normal and then Call. Then go to > capture, and set 100 100 Mic2 Mic1. Then place a call, > > AT+CFUN=1 > OK > ATD6; No luck with microphone here :( Using ttyUSB4, AT+CFUN=1 works, but ATD command on it just hangs the USB interface and I have to reload phy-mapphone-mdm6600 to reset the modem. > If you change Mic1 setting, GSM modem will likely crash. Have not seen that one here :) Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
