The R40 SoC has a GMAC (gigabit capable Ethernet controller). Add a
device node for it. The only publicly available board for this SoC
uses an RGMII PHY. Add a pinmux node for it as well.
Since this SoC also has an old 10/100 Mbps EMAC, which also has an
MDIO bus controller, the MDIO bus for the GMAC is labeled "gmac_mdio".
Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
---
arch/arm/boot/dts/sun8i-r40.dtsi | 34 ++++++++++++++++++++++++++++++++++
1 file changed, 34 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-r40.dtsi b/arch/arm/boot/dts/sun8i-r40.dtsi
index 173dcc1652d2..bd97ca3dc2fa 100644
--- a/arch/arm/boot/dts/sun8i-r40.dtsi
+++ b/arch/arm/boot/dts/sun8i-r40.dtsi
@@ -265,6 +265,19 @@
#interrupt-cells = <3>;
#gpio-cells = <3>;
+ gmac_rgmii_pins: gmac-rgmii-pins {
+ pins = "PA0", "PA1", "PA2", "PA3",
+ "PA4", "PA5", "PA6", "PA7",
+ "PA8", "PA10", "PA11", "PA12",
+ "PA13", "PA15", "PA16";
+ function = "gmac";
+ /*
+ * data lines in RGMII mode use DDR mode
+ * and need a higher signal drive strength
+ */
+ drive-strength = <40>;
+ };
+
i2c0_pins: i2c0-pins {
pins = "PB0", "PB1";
function = "i2c0";
@@ -451,6 +464,27 @@
#size-cells = <0>;
};
+ gmac: ethernet@1c50000 {
+ compatible = "allwinner,sun8i-r40-gmac";
+ syscon = <&ccu>;
+ reg = <0x01c50000 0x10000>;
+ interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "macirq";
+ resets = <&ccu RST_BUS_GMAC>;
+ reset-names = "stmmaceth";
+ clocks = <&ccu CLK_BUS_GMAC>;
+ clock-names = "stmmaceth";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ status = "disabled";
+
+ gmac_mdio: mdio {
+ compatible = "snps,dwmac-mdio";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ };
+ };
+
gic: interrupt-controller@1c81000 {
compatible = "arm,gic-400";
reg = <0x01c81000 0x1000>,
--
2.16.2
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
