On Wed, Dec 20, 2017 at 2:02 AM, Jassi Brar <jassisinghbrar@xxxxxxxxx> wrote: > Hi Mark, > > On Tue, Dec 12, 2017 at 10:59 PM, Mark Rutland <mark.rutland@xxxxxxx> wrote: >> Hi, >> >> On Tue, Dec 12, 2017 at 10:45:21PM +0530, jassisinghbrar@xxxxxxxxx wrote: >>> From: Jassi Brar <jassisinghbrar@xxxxxxxxx> >>> >>> This patch adds documentation for Device-Tree bindings for the >>> Socionext NetSec Controller driver. >>> >>> Signed-off-by: Ard Biesheuvel <ard.biesheuvel@xxxxxxxxxx> >>> Signed-off-by: Jassi Brar <jaswinder.singh@xxxxxxxxxx> >>> --- >>> .../devicetree/bindings/net/socionext-netsec.txt | 43 ++++++++++++++++++++++ >>> 1 file changed, 43 insertions(+) >>> create mode 100644 Documentation/devicetree/bindings/net/socionext-netsec.txt >>> >>> diff --git a/Documentation/devicetree/bindings/net/socionext-netsec.txt b/Documentation/devicetree/bindings/net/socionext-netsec.txt >>> new file mode 100644 >>> index 0000000..4695969 >>> --- /dev/null >>> +++ b/Documentation/devicetree/bindings/net/socionext-netsec.txt >>> @@ -0,0 +1,45 @@ >>> +* Socionext NetSec Ethernet Controller IP >>> + >>> +Required properties: >>> +- compatible: Should be "socionext,synquacer-netsec" >>> +- reg: Address and length of the control register area, followed by the >>> + address and length of the EEPROM holding the MAC address and >>> + microengine firmware >>> +- interrupts: Should contain ethernet controller interrupt >>> +- clocks: phandle to the PHY reference clock, and any other clocks to be >>> + switched by runtime_pm runtime_pm is a Linux thing and driver detail. >>> +- clock-names: Required only if more than a single clock is listed in 'clocks'. >>> + The PHY reference clock must be named 'phy_refclk' >> >> Please define the full set of clocks (and their names) explicitly. This >> should be well-known. >> > The issue is some implementations have just the 'rate-reference' clock > going in, while others may also have 1or2 optional 'enable' clocks > (which may go to other devices as well). > The driver only needs to know which clock to read the freq from, so it > expects that clock to be named 'phy_refclk', while the 'enable' clocks > can be named anything. It still needs to be documented. If there's differing number of clocks, then I expect a compatible string for each possible clock setup. Of course, differing number of clocks for the same block is often an error when multiple clock inputs are driven by the same source clock. Rob -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
