On Fri, Dec 22, 2017 at 09:32:03AM +0100, Simon Horman wrote:
> On Thu, Dec 21, 2017 at 05:18:58PM +0200, Vladimir Zapolskiy wrote:
> > From: Bogdan Mirea <Bogdan-Stefan_Mirea@xxxxxxxxxx>
> >
> > The present change is a bug fix for AVB link iteratively up/down.
> >
> > Steps to reproduce:
> > - start AVB TX stream (Using aplay via MSE),
> > - disconnect+reconnect the eth cable,
> > - after a reconnection the eth connection goes iteratively up/down
> > without user interaction,
> > - this may heal after some seconds or even stay for minutes.
> >
> > As the documentation specifies, the "renesas,no-ether-link" option
> > should be used when a board does not provide a proper AVB_LINK signal.
> > There is no need for this option enabled on RCAR H3/M3 Salvator-X/XS
> > and ULCB starter kits since the AVB_LINK is correctly handled by HW.
> >
> > Choosing to keep or remove the "renesas,no-ether-link" option will
> > have impact on the code flow in the following ways:
> > - keeping this option enabled may lead to unexpected behavior since
> > the RX & TX are enabled/disabled directly from adjust_link function
> > without any HW interrogation,
> > - removing this option, the RX & TX will only be enabled/disabled after
> > HW interrogation. The HW check is made through the LMON pin in PSR
> > register which specifies AVB_LINK signal value (0 - at low level;
> > 1 - at high level).
> >
> > In conclusion, the present change is also a safety improvement because
> > it removes the "renesas,no-ether-link" option leading to a proper way
> > of detecting the link state based on HW interrogation and not on
> > software heuristic.
> >
> > Fixes: d25e8ff0d5aa ("arm64: dts: renesas: Extract common Salvator-X board support")
>
> The above shuffles the code around but does not introduce the problem
> as far as I can see. Instead I think we should use:
>
> Fixes: dc36965a8905 ("arm64: dts: r8a7796: salvator-x: Enable EthernetAVB")
> Fixes: 6fa501c549aa ("arm64: dts: r8a7795: enable EthernetAVB on Salvator-X")
>
> > Signed-off-by: Bogdan Mirea <Bogdan-Stefan_Mirea@xxxxxxxxxx>
> > Signed-off-by: Vladimir Zapolskiy <vladimir_zapolskiy@xxxxxxxxxx>
I have applied this a fix for v4.15 with the updated Fixes tags above.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
