This patch cleans drivers/Makefile up by moving the pci/endpoint and pci/dwc entries from drivers/Makefile into drivers/pci/Makefile. Since we don't want to introduce any dependency between CONFIG_PCI and CONFIG_PCI_ENDPOINT, we now always execute drivers/pci/Makefile. Hence all Makefiles in drivers/pci/ were updated accordingly so no file is compiled when CONFIG_PCI is not defined. Signed-off-by: Cyrille Pitchen <cyrille.pitchen@xxxxxxxxxxxxxxxxxx> --- drivers/Makefile | 5 +---- drivers/pci/Kconfig | 1 + drivers/pci/Makefile | 11 ++++++++--- drivers/pci/host/Makefile | 2 ++ 4 files changed, 12 insertions(+), 7 deletions(-) diff --git a/drivers/Makefile b/drivers/Makefile index 1d034b680431..9757199b9a65 100644 --- a/drivers/Makefile +++ b/drivers/Makefile @@ -16,10 +16,7 @@ obj-$(CONFIG_PINCTRL) += pinctrl/ obj-$(CONFIG_GPIOLIB) += gpio/ obj-y += pwm/ -obj-$(CONFIG_PCI) += pci/ -obj-$(CONFIG_PCI_ENDPOINT) += pci/endpoint/ -# PCI dwc controller drivers -obj-y += pci/dwc/ +obj-y += pci/ obj-$(CONFIG_PARISC) += parisc/ obj-$(CONFIG_RAPIDIO) += rapidio/ diff --git a/drivers/pci/Kconfig b/drivers/pci/Kconfig index bda151788f3f..7eeb969ab86a 100644 --- a/drivers/pci/Kconfig +++ b/drivers/pci/Kconfig @@ -125,6 +125,7 @@ config PCI_PASID config PCI_LABEL def_bool y if (DMI || ACPI) + depends on PCI select NLS config PCI_HYPERV diff --git a/drivers/pci/Makefile b/drivers/pci/Makefile index c7819b973df7..7284a7f6ad1e 100644 --- a/drivers/pci/Makefile +++ b/drivers/pci/Makefile @@ -3,12 +3,15 @@ # Makefile for the PCI bus specific drivers. # -obj-y += access.o bus.o probe.o host-bridge.o remove.o pci.o \ +obj-$(CONFIG_PCI) += access.o bus.o probe.o host-bridge.o remove.o pci.o \ pci-driver.o search.o pci-sysfs.o rom.o setup-res.o \ irq.o vpd.o setup-bus.o vc.o mmap.o setup-irq.o +ifdef CONFIG_PCI obj-$(CONFIG_PROC_FS) += proc.o obj-$(CONFIG_SYSFS) += slot.o +obj-$(CONFIG_OF) += of.o +endif obj-$(CONFIG_PCI_QUIRKS) += quirks.o @@ -44,10 +47,12 @@ obj-$(CONFIG_PCI_ECAM) += ecam.o obj-$(CONFIG_XEN_PCIDEV_FRONTEND) += xen-pcifront.o -obj-$(CONFIG_OF) += of.o - ccflags-$(CONFIG_PCI_DEBUG) := -DDEBUG # PCI host controller drivers obj-y += host/ obj-y += switch/ + +obj-$(CONFIG_PCI_ENDPOINT) += endpoint/ +# PCI dwc controller drivers +obj-y += dwc/ diff --git a/drivers/pci/host/Makefile b/drivers/pci/host/Makefile index 34ec1d88f961..3b1059190867 100644 --- a/drivers/pci/host/Makefile +++ b/drivers/pci/host/Makefile @@ -34,6 +34,8 @@ obj-$(CONFIG_VMD) += vmd.o # ARM64 and use internal ifdefs to only build the pieces we need # depending on whether ACPI, the DT driver, or both are enabled. +ifdef CONFIG_PCI obj-$(CONFIG_ARM64) += pci-thunder-ecam.o obj-$(CONFIG_ARM64) += pci-thunder-pem.o obj-$(CONFIG_ARM64) += pci-xgene.o +endif -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
