This patch series adds support for the sunxi A83T ir module and enhances the sunxi-ir driver.
Right now the base clock frequency for the ir driver is a hard coded define and is set to 8 MHz.
This works for the most common ir receivers. On the Sinovoip Bananapi M3 the ir receiver needs,
a 3 MHz base clock frequency to work without problems with this driver (like in the legacy kernel).
To fix this issue I reworked the driver that this value could be set over the devicetree.
About 37 devices would have a devicetree change if this patch series would be applied.
Therfore I would like to ask you to give me some feedback about the patch series, before I finialize it.
Thanks in advance!
Philipp
Philipp Rossak (5):
[media] rc: update sunxi-ir driver to get base frequency from
devicetree
[media] dt: bindings: Update binding documentation for sunxi IR
controller
ARM: dts: sun8i: a83t: Add the ir pin for the A83T
ARM: dts: sun8i: a83t: Add support for the ir interface
ARM: dts: sun8i: a83t: bananapi-m3: Enable IR controller
Documentation/devicetree/bindings/media/sunxi-ir.txt | 14 ++++++++------
arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts | 7 +++++++
arch/arm/boot/dts/sun8i-a83t.dtsi | 15 +++++++++++++++
drivers/media/rc/sunxi-cir.c | 20 +++++++++++---------
4 files changed, 41 insertions(+), 15 deletions(-)
--
2.11.0
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
