From: Florian Fainelli
> It would be good to explain exactly how your hardware is broken
> exactly. I really do not think that such a fine-grained setting where
> you could disable, e.g: 100BaseT_Full, but allow 100BaseT_Half to
> remain usable makes that much sense. In general, Gigabit might be
> badly broken, but 100 and 10Mbits/sec should work fine. How about the
> MASTER-SLAVE bit, is overriding it really required?
There are plenty of systems out there where you'd want to disable
either HDX or FDX modes.
The MAC unit has to know whether the PHY is in HDX or FDX in order
to work properly. Many do not need to know the speed - since the
PHY is responsible for the tx/rx fifo clock.
Getting the negotiated speed out of the PHY can be difficult, while
the ANAR can easily be set.
Unfortunately it is usually impossible to disable the 'fall-back'
10M HDX.
David
��.n��������+%������w��{.n����z�{��ܨ}���Ơz�j:+v�����w����ޙ��&�)ߡ�a����z�ޗ���ݢj��w�f
