On Wed, Nov 29, 2017 at 08:32:34PM +0100, Niklas Söderlund wrote: > Documentation for Renesas R-Car MIPI CSI-2 receiver. The CSI-2 receivers > are located between the video sources (CSI-2 transmitters) and the video > grabbers (VIN) on Gen3 of Renesas R-Car SoC. > > Each CSI-2 device is connected to more then one VIN device which > simultaneously can receive video from the same CSI-2 device. Each VIN > device can also be connected to more then one CSI-2 device. The routing > of which link are used are controlled by the VIN devices. There are only > a few possible routes which are set by hardware limitations, which are > different for each SoC in the Gen3 family. > > To work with the limitations of routing possibilities it is necessary > for the DT bindings to describe which VIN device is connected to which > CSI-2 device. This is why port 1 needs to to assign reg numbers for each > VIN device that be connected to it. To setup and to know which links are > valid for each SoC is the responsibility of the VIN driver since the > register to configure it belongs to the VIN hardware. > > Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx> > Acked-by: Rob Herring <robh@xxxxxxxxxx> Acked-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> -- Sakari Ailus e-mail: sakari.ailus@xxxxxx -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
