> > > The sdcard detect pin on orange-pi-zero-plus2 is pulled up. > > > Fix cd-gpio description to enable sdcard detect. > > > > > > Signed-off-by: Sergey Matyukevich <geomatsi@xxxxxxxxx> > > > --- > > > arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts | 2 +- > > > 1 file changed, 1 insertion(+), 1 deletion(-) > > > > > > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts > b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts > > > index b6b7a561df8c..a42fd79a62a3 100644 > > > --- a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts > > > +++ b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts > > > @@ -71,7 +71,7 @@ > > > pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin>; > > > vmmc-supply = <®_vcc3v3>; > > > bus-width = <4>; > > > - cd-gpios = <&pio 5 6 GPIO_ACTIVE_HIGH>; > > > + cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>; > > > > Was able to detect and do mount with existing dts > > Did you try to boot from sdcard ? I am not able to boot my board from > sd-card without this change. As I mentioned earlier in my email > to buildroot mailing list, with mmc debug enabled I see that mmc > tries to init sd-card when I remove it from the slot. > > Maybe there is a minor differences between h/w versions or batches ? > What is you board version ? I tested on board v1.0. > > > I'm using same v1.0 Ok, lets skip this patch for now. I will double check v1.0 schematics and my board behavior. Though I see that mmc0 dts fragment in u-boot for this board also differs from the current kernel one: it uses 'cd-inverted' property. Regards, Sergey -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
