Hello
I have some minor comment below
On Thu, Oct 19, 2017 at 11:03:59AM +0200, Fabien Dessenne wrote:
> This module registers block cipher algorithms that make use of the
> STMicroelectronics STM32 crypto "CRYP1" hardware.
> The following algorithms are supported:
> - aes: ecb, cbc, ctr
> - des: ecb, cbc
> - tdes: ecb, cbc
>
> Signed-off-by: Fabien Dessennie <fabien.dessenne@xxxxxx>
> ---
> drivers/crypto/stm32/Kconfig | 9 +
> drivers/crypto/stm32/Makefile | 3 +-
> drivers/crypto/stm32/stm32-cryp.c | 1188 +++++++++++++++++++++++++++++++++++++
> 3 files changed, 1199 insertions(+), 1 deletion(-)
> create mode 100644 drivers/crypto/stm32/stm32-cryp.c
>
> diff --git a/drivers/crypto/stm32/Kconfig b/drivers/crypto/stm32/Kconfig
> index 602332e..61ef00b 100644
> --- a/drivers/crypto/stm32/Kconfig
> +++ b/drivers/crypto/stm32/Kconfig
[...]
> +/* Bit [0] encrypt / decrypt */
> +#define FLG_ENCRYPT BIT(0)
> +/* Bit [8..1] algo & operation mode */
> +#define FLG_AES BIT(1)
> +#define FLG_DES BIT(2)
> +#define FLG_TDES BIT(3)
> +#define FLG_ECB BIT(4)
> +#define FLG_CBC BIT(5)
> +#define FLG_CTR BIT(6)
> +/* Mode mask = bits [15..0] */
> +#define FLG_MODE_MASK GENMASK(15, 0)
> +
> +/* Registers */
> +#define CRYP_CR 0x00000000
> +#define CRYP_SR 0x00000004
> +#define CRYP_DIN 0x00000008
> +#define CRYP_DOUT 0x0000000C
> +#define CRYP_DMACR 0x00000010
> +#define CRYP_IMSCR 0x00000014
> +#define CRYP_RISR 0x00000018
> +#define CRYP_MISR 0x0000001C
> +#define CRYP_K0LR 0x00000020
> +#define CRYP_K0RR 0x00000024
> +#define CRYP_K1LR 0x00000028
> +#define CRYP_K1RR 0x0000002C
> +#define CRYP_K2LR 0x00000030
> +#define CRYP_K2RR 0x00000034
> +#define CRYP_K3LR 0x00000038
> +#define CRYP_K3RR 0x0000003C
> +#define CRYP_IV0LR 0x00000040
> +#define CRYP_IV0RR 0x00000044
> +#define CRYP_IV1LR 0x00000048
> +#define CRYP_IV1RR 0x0000004C
> +
> +/* Registers values */
> +#define CR_DEC_NOT_ENC 0x00000004
> +#define CR_TDES_ECB 0x00000000
> +#define CR_TDES_CBC 0x00000008
> +#define CR_DES_ECB 0x00000010
> +#define CR_DES_CBC 0x00000018
> +#define CR_AES_ECB 0x00000020
> +#define CR_AES_CBC 0x00000028
> +#define CR_AES_CTR 0x00000030
> +#define CR_AES_KP 0x00000038
> +#define CR_AES_UNKNOWN 0xFFFFFFFF
> +#define CR_ALGO_MASK 0x00080038
> +#define CR_DATA32 0x00000000
> +#define CR_DATA16 0x00000040
> +#define CR_DATA8 0x00000080
> +#define CR_DATA1 0x000000C0
> +#define CR_KEY128 0x00000000
> +#define CR_KEY192 0x00000100
> +#define CR_KEY256 0x00000200
> +#define CR_FFLUSH 0x00004000
> +#define CR_CRYPEN 0x00008000
Why not using BIT(x) ?
Why not using also directly FLG_XX since CR_XX are arbitray values ? like using instead CR_AES_CBC = FLG_AES | FLG_CBC
[...]
> +static inline void stm32_cryp_wait_enable(struct stm32_cryp *cryp)
> +{
> + while (stm32_cryp_read(cryp, CRYP_CR) & CR_CRYPEN)
> + cpu_relax();
> +}
This function is not used, so you could remove it
> +
> +static inline void stm32_cryp_wait_busy(struct stm32_cryp *cryp)
> +{
> + while (stm32_cryp_read(cryp, CRYP_SR) & SR_BUSY)
> + cpu_relax();
> +}
No timeout ?
> +
> +static inline void stm32_cryp_wait_output(struct stm32_cryp *cryp)
> +{
> + while (!(stm32_cryp_read(cryp, CRYP_SR) & SR_OFNE))
> + cpu_relax();
> +}
This function is not used, so you could remove it
[...]
> +static int stm32_cryp_check_aligned(struct scatterlist *sg, size_t total,
> + size_t align)
> +{
> + int len = 0;
> +
> + if (!total)
> + return 0;
> +
> + if (!IS_ALIGNED(total, align))
> + return -EINVAL;
> +
> + while (sg) {
> + if (!IS_ALIGNED(sg->offset, sizeof(u32)))
> + return -1;
-1 is not a good return value, prefer any -Exxxx
> +
> + if (!IS_ALIGNED(sg->length, align))
> + return -1;
> +
> + len += sg->length;
> + sg = sg_next(sg);
> + }
> +
> + if (len != total)
> + return -1;
[...]
> +static int stm32_cryp_copy_sgs(struct stm32_cryp *cryp)
> +{
> + void *buf_in, *buf_out;
> + int pages, total_in, total_out;
> +
> + if (!stm32_cryp_check_io_aligned(cryp)) {
> + cryp->sgs_copied = 0;
> + return 0;
> + }
> +
> + total_in = ALIGN(cryp->total_in, cryp->hw_blocksize);
> + pages = total_in ? get_order(total_in) : 1;
> + buf_in = (void *)__get_free_pages(GFP_ATOMIC, pages);
> +
> + total_out = ALIGN(cryp->total_out, cryp->hw_blocksize);
> + pages = total_out ? get_order(total_out) : 1;
> + buf_out = (void *)__get_free_pages(GFP_ATOMIC, pages);
> +
> + if (!buf_in || !buf_out) {
> + pr_err("Couldn't allocate pages for unaligned cases.\n");
You must use dev_err() instead. without it, it will be hard to know which subsystem said that error message.
[...]
> +static int stm32_cryp_cra_init(struct crypto_tfm *tfm)
> +{
> + tfm->crt_ablkcipher.reqsize = sizeof(struct stm32_cryp_reqctx);
> +
> + return 0;
> +}
You could simply remove this function
[...]
> +
> +static void stm32_cryp_cra_exit(struct crypto_tfm *tfm)
> +{
> +}
> +
> +static int stm32_cryp_crypt(struct ablkcipher_request *req, unsigned long mode)
> +{
> + struct stm32_cryp_ctx *ctx = crypto_ablkcipher_ctx(
> + crypto_ablkcipher_reqtfm(req));
> + struct stm32_cryp_reqctx *rctx = ablkcipher_request_ctx(req);
> + struct stm32_cryp *cryp = stm32_cryp_find_dev(ctx);
> +
> + if (!cryp)
> + return -ENODEV;
> +
> + rctx->mode = mode;
> +
> + return crypto_transfer_cipher_request_to_engine(cryp->engine, req);
> +}
> +
> +static int stm32_cryp_setkey(struct crypto_ablkcipher *tfm, const u8 *key,
> + unsigned int keylen)
> +{
> + struct stm32_cryp_ctx *ctx = crypto_ablkcipher_ctx(tfm);
> +
> + memcpy(ctx->key, key, keylen);
> + ctx->keylen = keylen;
You never zeroize the key after request.
[...]
> +static const struct of_device_id stm32_dt_ids[] = {
> + { .compatible = "st,stm32f756-cryp", },
> + {},
> +};
> +MODULE_DEVICE_TABLE(of, sti_dt_ids);
> +
> +static int stm32_cryp_probe(struct platform_device *pdev)
> +{
> + struct device *dev = &pdev->dev;
> + struct stm32_cryp *cryp;
> + struct resource *res;
> + struct reset_control *rst;
> + const struct of_device_id *match;
> + int irq, ret;
> +
> + cryp = devm_kzalloc(dev, sizeof(*cryp), GFP_KERNEL);
> + if (!cryp)
> + return -ENOMEM;
> +
> + match = of_match_device(stm32_dt_ids, dev);
> + if (!match)
> + return -ENODEV;
I think this test is unnecessary, at least it should be before the devm_kzalloc
Regards
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
