Use the correct interrupt flags and change the 'interrupt-parent', 'interrupts' property pairs to 'interrupts-extended'. Signed-off-by: Lothar Waßmann <LW@xxxxxxxxxxxxxxxxxxx> --- arch/arm/boot/dts/imx28-tx28.dts | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-) diff --git a/arch/arm/boot/dts/imx28-tx28.dts b/arch/arm/boot/dts/imx28-tx28.dts index 211e67d..3c852f7 100644 --- a/arch/arm/boot/dts/imx28-tx28.dts +++ b/arch/arm/boot/dts/imx28-tx28.dts @@ -328,8 +328,7 @@ reg = <0x20>; pinctrl-names = "default"; pinctrl-0 = <&tx28_pca9554_pins>; - interrupt-parent = <&gpio3>; - interrupts = <28 0>; + interrupts-extended = <&gpio3 28 IRQ_TYPE_NONE>; gpio-controller; #gpio-cells = <2>; interrupt-controller; @@ -341,8 +340,7 @@ reg = <0x38>; pinctrl-names = "default"; pinctrl-0 = <&tx28_edt_ft5x06_pins>; - interrupt-parent = <&gpio2>; - interrupts = <5 IRQ_TYPE_EDGE_FALLING>; + interrupts-extended = <&gpio2 5 IRQ_TYPE_EDGE_FALLING>; reset-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>; wake-gpios = <&gpio4 9 GPIO_ACTIVE_HIGH>; }; @@ -352,8 +350,7 @@ reg = <0x48>; pinctrl-names = "default"; pinctrl-0 = <&tx28_tsc2007_pins>; - interrupt-parent = <&gpio3>; - interrupts = <20 0>; + interrupts-extended = <&gpio3 20 IRQ_TYPE_EDGE_FALLING>; pendown-gpio = <&gpio3 20 GPIO_ACTIVE_LOW>; ti,x-plate-ohms = /bits/ 16 <660>; }; -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
