On Wed, Sep 20, 2017 at 03:52:55PM -0500, Rob Herring <robh@xxxxxxxxxx> wrote:
> On Sat, Sep 16, 2017 at 01:42:19PM +0300, Serge Semin wrote:
> > This parameters may be varied in accordance with hardware specifics.
> > So lets add the corresponding settings to the usb251x driver dts
> > specification.
> >
> > Signed-off-by: Serge Semin <fancer.lancer@xxxxxxxxx>
> > ---
> > Documentation/devicetree/bindings/usb/usb251xb.txt | 6 ++++++
> > drivers/usb/misc/usb251xb.c | 20 ++++++++++++++++----
> > 2 files changed, 22 insertions(+), 4 deletions(-)
> >
> > diff --git a/Documentation/devicetree/bindings/usb/usb251xb.txt b/Documentation/devicetree/bindings/usb/usb251xb.txt
> > index 3d84626d3..dd59a32e7 100644
> > --- a/Documentation/devicetree/bindings/usb/usb251xb.txt
> > +++ b/Documentation/devicetree/bindings/usb/usb251xb.txt
> > @@ -44,6 +44,12 @@ Optional properties :
> > device connected.
> > - sp-disabled-ports : Specifies the ports which will be self-power disabled
> > - bp-disabled-ports : Specifies the ports which will be bus-power disabled
> > + - sp-max-{power,current} : Indicates the power/current consumed by hub from
> > + an upstream port (VBUS) when operation as a self-powered hub. The value
> > + is given in mA in a 0 - 100 range (default is 1mA).
> > + - bp-max-{power,current} : Indicates the power/current consumed by hub from
> > + an upstream port (VBUS) when operation as a bus-powered hub. The value
> > + is given in mA in a 0 - 510 range (default is 100mA).
>
> These need units as defined in property-units.txt.
>
Ok.
> Why do you need power and current? Can't you calculate power?
>
These are different parameters of the device. They got different configuration
registers and descriptions:
max_power* - ... This value also includes the power consumption of a
permanently attached peripheral if the hub is configured as a compound
device, and the embedded peripheral reports 0mA in its descriptors.
max_current* - ... This value does NOT include the power consumption of a
permanently attached peripheral if the hub is configured as a compound
device.
Additionally as you can see, they both are measured in "mA", so it isn't
a real physical power.
> > - power-on-time-ms : Specifies the time it takes from the time the host
> > initiates the power-on sequence to a port until the port has adequate
> > power. The value is given in ms in a 0 - 510 range (default is 100ms).
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
