From: Philipp Rossak <embed3d@xxxxxxxxx> There is no need for pincontrol nodes when the pin is set to a GPIO Signed-off-by: Philipp Rossak <embed3d@xxxxxxxxx> --- This is Patch is a new version of the following patch: https://patchwork.kernel.org/patch/9934835/ changes since version 1: * vqmmc-supply was added again * The pincontrolers for the leds and gpio_keys were removed arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 20 -------------------- 1 file changed, 20 deletions(-) diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts index d756ff8..cc20d67 100644 --- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts +++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts @@ -64,7 +64,6 @@ leds { compatible = "gpio-leds"; pinctrl-names = "default"; - pinctrl-0 = <&pwr_led_bpi_m2p>; pwr_led { label = "bananapi-m2-plus:red:pwr"; @@ -76,7 +75,6 @@ gpio_keys { compatible = "gpio-keys"; pinctrl-names = "default"; - pinctrl-0 = <&sw_r_bpi_m2p>; sw4 { label = "power"; @@ -98,7 +96,6 @@ wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; pinctrl-names = "default"; - pinctrl-0 = <&wifi_en_bpi_m2p>; reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */ }; }; @@ -190,23 +187,6 @@ status = "okay"; }; -&r_pio { - pwr_led_bpi_m2p: led_pins@0 { - pins = "PL10"; - function = "gpio_out"; - }; - - sw_r_bpi_m2p: key_pins@0 { - pins = "PL3"; - function = "gpio_in"; - }; - - wifi_en_bpi_m2p: wifi_en_pin { - pins = "PL7"; - function = "gpio_out"; - }; -}; - ®_usb0_vbus { gpio = <&pio 3 11 GPIO_ACTIVE_HIGH>; /* PD11 */ status = "okay"; -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
