Hi Stefan,
>>> Add basic support for Broadcom serial slave devices.
>>> Probe the serial device, retrieve its maximum speed and
>>> register a new hci uart device.
>>>
>>> Tested/compatible with bcm43438 (RPi3).
>>>
>>> Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxx>
>>> ...
>>>
>>> +static int bcm_serdev_probe(struct serdev_device *serdev)
>>> +{
>>> + struct bcm_bt_device *bcmdev;
>>> + u32 speed;
>>> + int err;
>>> +
>>> + bcmdev = devm_kzalloc(&serdev->dev, sizeof(*bcmdev), GFP_KERNEL);
>>> + if (!bcmdev)
>>> + return -ENOMEM;
>>> +
>>> + bcmdev->hu.serdev = serdev;
>>> + serdev_device_set_drvdata(serdev, bcmdev);
>>> +
>>> + err = of_property_read_u32(serdev->dev.of_node, "max-speed", &speed);
>>> + if (!err)
>>> + bcmdev->hu.oper_speed = speed;
>>> +
>>> + return hci_uart_register_device(&bcmdev->hu, &bcm_proto);
>>> +}
>>
>> We do not need any GPIO for reset lines or anything else for the rPI3?
>>
>
> unfortunately we don't have full schematics for RPI3, but according to firmware dt-blob.dts [1] there is a GPIO called BT_ON. This GPIO is controlled by the GPIO expander on the RPI3 board. The necessary driver for this expander is still out of tree (last mainlining attempt [2]).
so who handles this GPIO then right now (or any other GPIO for that matter)? I have seen Bluetooth being enabled and operational, but I really want to get this working in a plain upstream Fedora and without using hciattach or btattach.
Regards
Marcel
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
