On 07/04/2017 06:30 PM, Philippe CORNU wrote:
> The Orise Tech OTM8009A is a 3.97" 480x800 TFT LCD panel connected using
> a MIPI-DSI video interface. Its backlight is managed through the DSI link.
>
> Signed-off-by: Philippe CORNU <philippe.cornu@xxxxxx>
> ---
> .../bindings/display/panel/orisetech,otm8009a.txt | 20 ++++++++++++++++++++
> 1 file changed, 20 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
>
> diff --git a/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt b/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
> new file mode 100644
> index 0000000..0bb8237
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
> @@ -0,0 +1,20 @@
> +Orise Tech OTM8009A 3.97" 480x800 TFT LCD panel (MIPI-DSI video mode)
> +
> +The Orise Tech OTM8009A is a 3.97" 480x800 TFT LCD panel connected using
> +a MIPI-DSI video interface. Its backlight is managed through the DSI link.
> +
> +Required properties:
> + - compatible: "orisetech,otm8009a"
> + - reg: the virtual channel number of a DSI peripheral
> + - reset-gpios: a GPIO spec for the reset pin (active low). (Optional)
> +
> +Example:
> +&dsi {
> + ...
> +
> + panel@0 {
> + compatible = "orisetech,otm8009a";
> + reg = <0>;
> + reset-gpios = <&gpioh 7 0>;
Hi All,
I should have written instead:
+ reset-gpios = <&gpioh 7 GPIO_ACTIVE_LOW>;
reset-gpios is active low and the define GPIO_ACTIVE_LOW = 1 so the
example was not good.
I will send soon the v2 with the correction.
Many thanks
Philippe
> + };
> +};
> ��.n��������+%������w��{.n����z�{��ܨ}���Ơz�j:+v�����w����ޙ��&�)ߡ�a����z�ޗ���ݢj��w�f
